Indexable reamerinsert setting method

User Guide
Indexable reamer insert setting method
[ Inserts mounting ]
1
2
3
①
•Turn wedge screw to
180 ~360 counter clockwise
4
②
•Turn clamp screw
① Top: counter clockwise
② Bottom: clockwise
•Take out an insert and clean
the insert seat
•Put insert to 2 wedges stopper
•Fix the insert with clamp
①Top: clockwise
②Bottom: counter clockwise
[ Mounting equipment ]
•Model: KIRSD-210
•Maximum setting reamer Dia.: Ø60×210㎜(Ø2.362×8.267inch)
•Easy and quick mounting
•Available for not only standard reamer but special and mono tool reamer
•Special equipment is needed for special reamer over the maximum range
Insert setting fixture(KIRSD-210)
[ Mounting insert with the equipment ]
1
•Fix a reamer with 2 centers
•Set gauge '0' based on pad
2
3
•Turn the reamer to reach
the gauge
•Turn wedge screw to adjust insert height and back taper
① insert front: +0.015~+0.020㎜(0.00059~0.00078inch)
② insert rear: +0.005~+0.010㎜(0.000019~0.00039inch)
③ back taper: 0.010~0.015㎜(0.00039~0.00059inch)
[ Back taper effect ]
•Low cutting load and better chip evacuation improve surface finish
•Poor back taper causes unstable machining, quick wear and bad surface finish
•Back taper: the height of the front of insert should be lower than the rear(0.010~0.015㎜/0.00039~0.00059inch)
[ Mounting insert with the Micrometer ]
•You may use shelf with 2 centers or bench center,
without mounting equipment
※Note : Micrometer is not desirable due to chipping
on the edges
Web
www.korloy.com
E-mail
korloy@korloy.com
20101015
UG01-EM-01