online catalog

1/4" Offset Driveline Kit
Bolt-On Hardtail for Sportster
Models
Weld-On Hardtail for Big Twins
In addition to a chrome primary spacer this kit
includes a chrome transmission plate, bolts,
O-rings, sprocket shaft spacer and rear pulley
spacer. Permits the use of 1/2" wider tires in a
stock chassis.
17289
Fits Softail models from 86-99
A bolt-on unit lengthens the wheelbase by 4
1/2" and lowers the bike 4". The oil tank to use
with this frame is a CC #12599
08892
For Sportster models with mechanical
rear brakes 57-78
A quick and easy method of converting swingarm frames to rigid. It has the same wheelbase
and ride height as stock.
08893
Fits hydraulic drum brake 4-speed
swingarm frames 58-72
Offset Transmission Plates
HKC Axle Screw
681866
Frames
681867
HKC retro style rear axle adjuster
screws for rigid frames 3/8 UNF
HKC retro style rear axle adjuster
screws for Softail style frames 3/8 UNC
These 1-inch offset mounting plates for
5-speed Softail transmissions, make assembly
of Wide Drive swingarm or extra wide rigidframed customs a snap. The hot set-up for
building that extra-wide ride.
17285
Chrome mounting plate
17286
Raw steel mounting plate
14
86615
Weld-On Hardtail for Sportster
Models
Fits early Sportster models with mechanical
rear brakes. It forms an almost-perfect straight
line with the frame backbone, and lengthens
the motorcycle by 4" and lowers it 4". The oil
tank to use with this frame is a CC #12599.
08889
Fits Sportster models 57-78
14.12
Offset Kits for Twin Cam 88
Softail Models
These kits move the primary and the rear belt
position 20mm or 25mm outward to provide
clearance for larger tires, while leaving the
engine in its original position. Includes precision mainshaft, clutch pushrod, special starter
bushing, primary spacer and hardware kit. Fit
all Softail models from 00-06.
86615
20 mm offset kit (shown)
686216 25 mm offset kit (uses the Original
Equipment pulley, but includes a longer mainshaft 5th gear)
Rear Wheel Pulley Spacers
Billet aluminum spacers permit custom alignment of rear wheel pulleys. Can be used with
many wide rear tire kits and frames. Will not
fit 00-Up wheel assemblies with sealed bearing
style hubs.
Natural Aluminum Finish
42691
.250"-thick
42692
.375"-thick
42693
.500"-thick
42694
.750"-thick
42695
.937"-thick
42696
1.100"-thick
42697
1.250"-thick