FACTSHEET KF jet insert.

Transcription

FACTSHEET KF jet insert.
English
FACTSHEET
KF jet insert.
Knot-free air interlacing for texturing
HEBERLEIN® KF jet insert.
Interlacing without visible interlacing knots
The KF jet insert is the optimal solution for knot-free air interlacing of DTY
yarns. Although the yarn is combined, it shows no visible interlacing knots.
Consequently, the fabric does not have any interlacing knots, either.
Knot-Free Interlacing
In knot-free interlacing, the individual filaments are easily
bundled by means of an air blast. Visible knots in the fabric are a
thing of the past. This technology is suitable for filament yarns
made of polyester.
KF jet insert
Features and Benefits
• Very gentle treatment of the yarn, especially
suited for micro-filament and polyester yarns
• The air stream ensures that the filaments are
bundled and can therefore be easily reeled off the
package
• Leaves no visible, disruptive interlacing knots
behind in the fabric
2
• Cost-effective
• High-quality ceramic parts
• Simple maintenance
HEBERLEIN® KF jet insert.
Technical Data
Count range
Jet insert
Count range [dtex] (the = 0.9 dtex)
Air
consumption 1
qvn [m3/h]
KF050
0.350(pe+1)
KF150
0.488(pe+1)
KF250
0.784(pe+1)
KF450
1.391(pe+1)
75
1
100
130
200 240
330 360
660 700
Under standard conditions according to DIN 1343: temperature = 0 °C, pressure = 1.01325 bar, relative humidity = 0 %, 1 standard cubic metre = 1.293 kg (psi = 14.7 x bar, CFM =
0.588 x m3/h)
qvn = air consumption [m3/h], pe = overpressure [bar]. Formula applies from 0.8 bar
= Typical applications
= Threshold
Yarn characteristics
Knot-free
interlaced yarn
DTY, PES dtex150/f48, KF150, 2.5 bar, 700 m/min.
Interlaced yarn
DTY, PES dtex150/f48, P243, 1.2 bar, 700 m/min.
Non-interlaced yarn
DTY, PES dtex150/f48, 700 m/min.
Compatibility
– Heberlein® SlideJet-2 *
– Heberlein® SwissJet *
* Without yarn guide
3
Compressed air requirements
– Overpressure: 2.0 … 4.0 bar
– Max. residual oil: 0.1 mg/m3(class 2*)
– Max. residual particles: (class 2*)
– Particle size 1 µm
– Particle density 1 mg/m3
– Max. residual water: (class 5*)
– Residual water: 7,732 g/m3
– Pressure dew point + 7 °C
4
Heberlein AG
Bleikenstrasse 11, 9630 Wattwil, Switzerland
T +41 71 987 44 44, F +41 71 987 44 45, info@heberlein.com, www.heberlein.com
Subject to change without prior notice.
Revision status v 1.1603
* Quality class according to DIN ISO 8573-1