lnstructions for Use - Amazon Web Services

SUTER DHLL]XE
THTERAPY CYCTOPAD
with
Cy
cloid Poly mo dulatio n
lnstructions for Use
For aln ost half * cewturyo lt{iagara
Therapy pratlucts kat,e been
people worldwide"
titne again, that the unrivalted Niagara cycloidal vihration systena,
an integral part af all our products, brings relief to stffi painful joints
and uching muscles.
This unique vibratory message action delivers gentle, passive exercise to
&re&s af wusaular pain or tensian, impra,-ing circwlatian and
relaxing the muscles arourud awy puinful areas or joints.
sw,rr.
Whst fs Cy c{oidfffio{yxreodwlatisye?
The unique Niagara eccentric
motot incorporated into all our products, produces an
elliptical moyement, rather like a gyroscope. This, ultimateLy creates a cycloidal
- a multi-directional, three way wave, moving north/south, east/west and in a
circular direction all at the same time. The end result is a deep, penetrating massag3,
which provides a multitude of benefits with
no harntful side eJJbcts.
vibration
Polymodulation is yet another step forward
in the application of this wnpercLlleled
massage systen':, enabling you to enjoy
Tlree dinertsionaL
Ctcloklal action
wates
This new action, built into the existing
system, allows two alternatives, both
highly beneficial, forms of vibratory
action to be selected.
One is a constant frequency, giving a
steady, continuous cycloidal action. The
new cycloid polymodulated action,
produces a varying frequency, which
creates a pulsating, or surging action.
This provides an even deeper
beneficial effect.
the benefits of passive exercise.
wherever you may be.
The speed of either system is easily
controlled by the use of the massage
motor control.
',4'
i,, .., .:.ir .,,. ,, , , ,. ,i r.
..
,,
Many people will flnd the new cycloid
polymodulation action more beneflcial
in the treatment of their condition,
achieving even better results, as this
new action further enhances the
already well known benefits of
Niagara's cycloid action system.
Used regularly and for lengths of time which suit you best, you will find that your Cyclopad can
provide comfort and relief. Illustrated on the following pages are some suggested ways of using your
Cyclopad/Hand Unit, but experimentation could be necessary for you to gain the maximum benefit.
NOTE:
IF YOUR CONDITION is in an inflamed state we recommend that you discontinue
use on that area until the inflammation subsides.
NEVER use the Cyclopad/Hand Unit under
a blanket, or obstruct, in any way,
the ventilation holes in the motor housing.
REMEMBER the motor must be allowed to 'breathe'.
NEVER pick up the Cyclopad/Hand Unit by the electrical cable.
ON NO ACCOUNT should embrocation or similar lotions be allowed to come
into contact with the outer casing.
TAKB CARE to prevent string, hairpins etc. from entering the air vents.
Your Cyclopad
is
fitted with a control
panel, connected to your pad. The pad
itself is connected to the mains point by a
3.5 metre length of cable.
This controls the motor speed. The controi knob
is scaled tiom 1 to 9 - the hisher the number. the
faster the motor speed.
I
:
The timcr control is graduated in a
clockwise directiorr, with scttings of 0 to
60 minutes in 10 rninute intervals. Hrving
set the time rcquired. the tirner will
automatically switch olf the motor at the
end of the chosen period. The timer can
be overidden by turring the timer cortrol
knob anticlockwise to the 0 position until
a click is heard.
Please note:
When the timer has automatically
switched off or been manually cancelled
please turn the timer fully
anticlockwise to the 0 position until a
click is heard you must then wait 10-12
seconds before the timer can be
switched on or set to a new time period.
Pain, such as lower back pain, and that associated
with postural fatigue, post exercise spasm or
athletic injuries, is often the result of muscular
spasm or tight, taut muscles. Similarly, the pain
associated with rheumatism and lumbago is often
caused by the stiffness of muscular spasm, and by
increasing the blood circulation to the affected
area, the pain can be subdued.
To help ease many types of muscle and joint
pain, sit or lie with the affected area on the pad.
Set the motor massage control to 3 or above and
apply for 15 to 30 minutes.
Relief will usually last for several hours, but
remember, it can be achieved repeatedly by
daily use, as required, over a period of weeks,
months and even years, without the harmful side
effects sometimes associated with the use of
pills or drugs.
The use of your Niagara equipment will not
eliminate the underlying cause of the pain, but it
will help to increase the circulation and provide
a more relaxed muscle function, often resulting
in increased mobility.
:l;::r
This is the black rocker switch at the bottom,
right of the control panel. It displays l/0 positions
only. When the Cycloid Polymodulation vibration
is required, depress to the 1 position. This will
allow the motor to change from a fixed to a
modulated vibration. Depressing the rocker switch
to 0 will restore the fixed vibration.
'r:,4:ri ,ri:ai'::a'
fo
nelp achieve general relaxation and relief
from simple tensions, the best results are
obtained by placing the pad behind the back, as
shown in figures l9 and 20. Another soothing
and relaxing application is to the lower limbs
(figure 15).
Set the motor massage control at 5, 6 or 7
(depending on personal pref-erence) and use
l5 to 30 minutes.
for
:1.,' a.t
t...t:. :'
Massage has long been used to help relieve
fatigue and drowsiness, and now Niagara
equipment offers this as a single, convenient unit
f'or home use.
Set the massage control to the higher speeds,
according to your own preference and comfort.
Use the massage pad, preferably over the entire
body but particularly on the back, for
approximately 30 minutes. The invigorating
effects of such an application are quite
remarkable.
To help increase peripheral blood circulation in
the area of application, place the part of the
body affected (i.e. hands, feet, etc.,) on the pad
as shown in figures 13,14,15 and 22. Set the
massage control at 4/5 or above and apply fbr 20
to 30 minutes.
ll'=,,,.---.',..:,,::t:
TIME:
SPEED
-
-'VE:--
SPEED:_
TIME:
ii'
:.::
SPEED:
TIME:-
SPEED:
SPEED:
TIME:-
SPEED
SPEED
TIME:
SPEED
r....
-
TIME:-
SPEED
TIME:
-
TIME:
SPEED
-
TIME:
-
-
TIME:
SPEED:
TIME:
-
TIME:
SPEED
TIME:-
SPEED
SPEED
TIME:-
SPEED:
TIME:_
SPEED
-
SPEED:
TIME:
.
,
-
TIME:
SPEED:
TIME:
_
SPEED:
-
TIME:
SPEED:
-
_
d
*
ig
L3
ffi
E
E
!
I
Tke cunebirued actiCIre 0f the
Ni*g*r* Cyc{ap*d uwd Xfmued Urcdt Systems
provides ffiwefsrt arad pa{ra r*lief
wit&eaeat €qu{i{ dre $xe $ie{d.
Before connecting this appliance, please check
that the supply voltage and frequency correspond
with those stated on the rating plate, rnounted on
the reverse side of the control panel.
This appliance should be fitted with a suitably
approved plug, for use in the country of
destination.
The plug may be of moulded construction, or of
the fitted type, and should adhere to BS 1363.
Some export items may be supplied with no plug
1ifted.
A 34' fuse should be fltted to the plug or circuit,
either in the adaptor or at the distribution board.
mouldetL or Jitted plug Jor any redson,
the supltlied plug should be cut J|om
the cable ancl a.suitable retrtlacentent,
described ctbctve, Jitted. Onc:e
removed.frum the Jlerible cable, the
suppl.ied plttg shotrld be desposed oJ
immediately, to avoid the risk oJ
electroculiott.
cLs
The fuse cover should be
up. using the blade of a screwdriver.
1er
er.,
. . Remove the cover by undoin-u thr
eentral rcrew belr,l een the connection pin'.
In either case, remove the fuse and replace rt
a new one of the same value, which shoLr.:
be A.S.T.A. approved to BS 1362.
The fuse cover or plug cover must be refitted
with
before use.
lf
the fuse cover or plug cover is lost, the plu-r
must be not be used until a replacement is
obtained. Replacernents may be obtained fion.i
Niagara Manuf acturing Limited.
MODEL
VOLTAGE
FREQUENCY
POWER
CLASSIFICATION
H.U. 75 and SDTP
23OV5OHZ
28W
tr
!
J Jlq'
;'tlfl;:'iliJ.' i tr{'Jdriii f#l\,ii!{stiid,'c/i'e
r"tii
r,,.,rn
!r,rirs
IiL;lt
r."rr,
ltltl
t,r'
Itt.
.
l,ti
a.
i }t".rf {'iJi
--
Rest and relax more easily and naturally.
Soothe rheumatic pains whenever they occur.
Ease simple nervous tension and the
resultant fatigue.
Increase circulation where applied.
Reduce high blood pressure.
A leading hospital has shown
that cycloidal vibration will substantially
Ease hip pain:
reduce the hip pain associated with
osteoarthritis (wear and tear).
Improve joint mobility.
Ease sore, aching muscles.
Reduce swellings due to excess tissue fluid.
Ease high and low back pains whenever they
occur. Cycloidal vibration has been shown to
reduce pain and spasm in non
nerve-entrapment back pain sufferers.
Ease arthritic pain and increase mobility.
T Fe r; se s *" se *8 s
*f s rs t i sfx * ri #s. s {
dJ {v?.
{
"{"
:t, w
*
f{ ir;grxr*'s grr*s€d irs"*
rxs €*ra#*ffi irs ttr*fi*I;irl rsf
{:{}scfds"{?
t
Fe.
* r ts,p *. x; { i. r:
c?e {E H
s {} g
# $ r # # {-E {: { s
s" { {E aq € rE
*,
p-i
Your appliance should be cleaned
regularly by wiping the cover with a
damp cloth (a mild tablet soap may be
used, care should be taken to use a
clean damp cloth afterwards). The
ventilation holes in the motor housing
"-'1'
Niagara Manufacturing Limited has a
customer liason department, which will
be happy to help you with any enquiry
you may have regarding the range of
Niagara equipment and its uses.
should be kept clean and free from dust
by passing a vacuum cleaner hose over
the ventilation slots.
Your Cyclopad has been designed to
require little maintenance from you. No
additional lubrication is required. Kept
clean and used sensibly in accordance
with these instructions, it will provide
you with years of trouble free service.
Should your products need servicing,
please call our Customer Service Line
on01145811200
ii:'i',:,:::a:t:: L::::,::':'
If
the electrical supply cable on this appliance is damaged,
it must be replaced by a special cable, obtainable
exclusively from Niagara Manufacturing Limited.
All servicing must be carried out by our Service
Depafiment at the address below.
0t 74s 811200
(On-site service calls are only
avoiloble for Therapy Chairs.l
REPRESENTAIIVE'S NAME. ADDRESS & TELEPHONE
C€
Colomendy lndustial Estate,
Rhyl Road, Denbigh, Denbighshire, North Wales, UK, LL16 5TS.
Notice:
Should youi docfor require tilrther inlbnnation about any Niagara product, please ask hlm to contact the Company
at the above address.
I[
accordalce with an on-goirlg policy of research and development, the Compaty reserves the righl to nake
alterations and modifications to designs and spccifications without pdor ndice.