Ford – 170 x 96 - Medix Specialty Vehicles Inc.

Ford – 170 x 96
E-450 SuperDuty Cutaway Van
Type III-AD Ambulance Conversion
This document is the exclusive property of MEDIX Specialty Vehicles, Inc. and considered
“on loan” to those to whom MEDIX has distributed it.
Ford MSVII 170 x 96
Type III Ambulance Conversion
The MSVII is a 170”L x 96”W Type III modular
body with 72” head room for interior comfort
mounted on a Ford E-450, V-10 gas chassis. The
.125” exterior walls of the ambulance retain the
smooth, strong look that is our signature while
our new, enhanced door design adds to the unit’s
aesthetic appearance and modular performance.
Our commitment to quality, product integrity
and occupant safety is your assurance of our
concern for the wellbeing of the patient and the
men and women who provide lifesaving care in
the backs of our modular ambulances… a
commitment we’re proud of.
We hope this “walk-around” of the Ford MSVII 170 x 96 Type III by MEDIX Specialty
Vehicles, Inc. will assist you in making an informed choice about purchasing a Ford 170
modular ambulance.
Ford MSVII 170 x 96
Type III Ambulance Conversion
Ford MSVII 170 x 96
Type III Ambulance Conversion
Ford MSVII 170 x 96
Type III Ambulance Conversion
Ford MSVII 170 x 96
Type III Ambulance Conversion
Overall Width
96”
Overall Length
170”
Overall Height
109”
Completed Vehicle Weight- 10,400 lbs.
Usable Payload- 4,100 lbs.
Wheel Base
158”
GVWR – 14,500 lbs.
Front GAWR- 5,000 lbs.
Rear- GAWR- 9,600 lbs.
Ford MSVII 170 x 96
Type III Ambulance Conversion
Testing the doors with a static load of 74,279 lbs.
NOTE: Unit tested without corner or roof radius cap extrusions
which are cosmetic only
Full length vertical welds
at four corners and full
perimeter weld around the
roof radius complemented by 6”-8” interval welds
at the four vertical interior corners and the entire
interior of the roof perimeter.
At Medix Specialty Vehicles, we do not design our ambulances to just meet the Federal guidelines; we work hard to
exceed them. Safety was engineered and constructed into the unit as a standard feature. We took the certification
process to the extreme by instructing the independently certified laboratory to push the limits on the static load
test. They put over 74,000 pounds of force on our ambulance body, which is over two times the required amount,
with no unfavorable structural effect and the exterior doors functioned normally during and after the test.
Ford MSVII 170 x 96
Type III Ambulance Conversion
Pre-drilled holes and Penetrations,
body sanded, washed with degreaser
and full prepped for paint
PPG Delfleet Base Coat/Clear Coat
Process with a Minimum
5 mil Final Finish
The .125” Exterior Skin Produces a Smooth,
High Gloss Exterior Surface that is enhanced
by our Standard Full Sand and Buff Process
Ford MSVII 170 x 96
Type III Ambulance Conversion
Aisle Width
50” at Squad Bench
Floor Length
155”
Interior Headroom
72”
The Chassis
Medix is an approved Ford QVM Builder
TransmissionAutomatic 5-Speed
Rear Axle Ratio- 4.56:1
Engine6.8L V-10 Gasoline
Fuel Economy - 7-12 mpg
47-A Ambulance Prep Pkg
The Chassis
(1)-Single Access to the ALSBattery Storage Area
(2)-Open Access to ALS storage
with sealed Battery tray below
(4)-Batteries- Three 750 CCA Total CCA- 2,250
(1) Under the hood, (2) on roll-out tray
(3)-Sealed battery Access with
removable cover for quick access
225/75R16 E BSW Tires & Spare
Shipped Loose
The Chassis
Stainless Steel Wheel Liners w/ valve
extensions- optional
Tilt Steering Wheel; Power Windows, Door Locks
& Mirrors; Dual Captain’s Chairs w/tilt back;
AM/FM/CD Radio w/4-spkrs; molded rubber
floor mats
Fuel Fill w/cast aluminum bezel
With Stainless Drip Plate
Environmental Systems
HVAC Unit Output Vents
& Filtered Return Air
Located above Walk-Thru
Free-Blow HVAC System36K BTU Heat- 32K BTU Cool
720 CFM multi-speed fan, Thermostatic
Control
Fresh
Air
Intake
Powered
Exhaust
Vent
Power Distribution & Control
Electrical Cabinet
Vented, latching, hinged door
Located above Walk-Thru
Common component circuit
breakers and relays
Power Distribution & Control
Front Console
Switch Control Panel,
Panel for Radios, Cup Holders, Siren
Control Head.
Map Book/Report Book Storage Slots optional
Power Distribution & Control
Switch Control Panel
Digital Volt/Amp Meter
Back lighted Legends
Indicator Lamps
Carson SA 500 Siren Control Head,
multi-tone
CPI Thru-the-Bumper
Mounted Siren Speakers
Power Distribution & Control
Rear Action Area,
Standard 16” LED Strip
Light
Rear Switch Control Panel
w/HVAC Thermostat Control
12 VDC Outlet w/cover
125 VAC
Duplex Outlets
Emergency Lighting
Emergency Lighting
(3) Whelen 900 Series Halogen on Front Wall
Note: (7) Whelen 900 Series LED Shown
Whelen 900 Red Halogen Warning Lights on all side,
rear corners and mid-body
Whelen 900 Amber Halogen Warning Light rear
center
Whelen 7x3 Red LED Warning Lights on fenders and
above Rear Wheel Wells as Intersection Lights
Whelen 5x2 LED Warning Lights as Grille Lights
NOTE: Shown with Add’l set of 5x2 Clear LED
Patient Compartment Interior
Ten Critically Spaced Dome Lights; two folddown IV Hangers; Overhead Grab Rail
Space for the Patient,
Space for the Medic
Easy, safe access to interior
Patient Compartment Interior
ALS Cabinet- Lower Dual locking; Middle
Drawer, Mid-Upper Dual 3/8” Lexan,
Upper Dual Storage w/Sliding Lexan
Note: Optional Configurations Available
Patient Compartment Interior
Automotive style Technician’s Seat w/ Type
II Lap & Shoulder belt
(Optional Six Point Belt shown)
Optional Swivel Base
(Optional Storage w/drop-down latching door
not shown)
Patient Compartment Interior
Miscellaneous Storage
behind Tech Seat- Inverter
Pre-Wire; Vacuum pump
Functional, Ergonomical,
Accessible
Patient Compartment Interior
Vacuum-Formed Cushions and Pads
Removable A-Bar
Sharps/Waste
Easy Open/Close
Self Supporting SB Lid
Patient Compartment Interior
Action Area Overhead
CPR Seat with
Overhead Cabinets
Rear Action Area
Patient Care Systems
Vacuum Gauge Hard Plumbed to Vacuum
Pump; Dual Quick-Connect Oxygen Outlets
2-in Action Area, 1- over Squad Bench and 1
Centered over the Head of the Stretcher
Glove Holder
Optional Location Shown
Recessed Suction
Optional Sharps and Waste
Disposal
Protective & Safety Surfaces
•Stainless steel threshold w/safety
grip tape
• LED Step Light
•Removable Matte Flex Step Liner
•One Piece Stainless steel threshold w/safety
grip tape
•Aluminum grip strut, flip-up bumper
step
•Reflective tape on bumper edge
Exterior Compartmentation - Streetside
COMPT 2- Open Storage
w/adjustable shelf
COMPT 1- Oxygen
Storage; open storage Wide
Enough to accommodate
any OTS System
COMPT 3- Inside/Outside
access w/Adjustable shelf &
open storage below
Exterior Compartmentation - Curbside
COMPT 5- Sealed, Easy Access
Battery Storage w/Roll-Out Tray
COMPT 4- ALS
Cabinet- Inside
/Outside access
COMPT 6- Back Board Storage
w/Adjustable belts
(Shown w/ optional divider)
Paint, Decals, Lettering
Paint Stripe- Optional
Star-of-Life Decals- Optional
Lettering- Optional
Warranties
Structural Warranty – Lifetime (non-transferrable)
Electrical Warranty- 72 Months/72,000 Miles
Limited Warranty- 12 Months/12,000 Miles
Paint - 48 Months
Contact MEDIX
3008 Mobile Drive  Elkhart, IN 46514 U.S.A.
Ph- 574.266.0911 Fx- 574.266.6669
sales@medixambulance.com
techsupport@medixambulance.com
www.medixambulance.com
MEDIX Specialty Vehicles, Inc.
3008 Mobile Drive  Elkhart, Indiana 46514 U.S.A.
PH- 574.266.0911 FX- 574.266.6669
www.medixambulance.com
Due to on-going product improvements and changing requirements of the ambulance industry, Medix Specialty Vehicles Inc. reserves the
right to change this specification and related product without prior notice and without obligation to change prior product or parts.