docCarProg Lexus immo manual
download 
Report Transcription
CarProg Lexus immo manual
S4.2 CarProg LEXUS immobiliser manual Lexus model ES300 ES330 GS300 GS300 GS400 GX470 IS200 IS300 LS200 LS400 LX450 LX470 RX300 RX330 SC300 SC400 SC430 Year 1998-2001 2002-2004 200419981998-2000 200120042000-2004 2000-2004 1997-1999 19991997-1999 19991997-1999 19991999-2004 2005199919991997-1999 19991997-1999 19992004- Transponder key type TEX TEX TEX/CR TEX TEX TEX TEX/CR TEX TEX TEX TEX TEX TEX TEX TEX TEX TEX/CR TEX TEX/CR TEX TEX TEX TEX TEX/CR All right reserved www.codecard.lt Instruction S4.2.1 S4.2.2 S4.2.3 S4.2.1 S4.2.2 S4.2.1 S4.2.3 S4.2.2 S4.2.2 S4.2.1 S4.2.2 S4.2.1 S4.2.2 S4.2.1 S4.2.2 S4.2.2 S4.2.3 S4.2.2 S4.2.3 S4.2.1 S4.2.2 S4.2.1 S4.2.2 S4.2.3 1 S4.2.1 Older Lexus immobiliser system with separated immo box and Texas transponder (4D by Silca). Immobiliser box are located near to ignition key. Usually this is black or brown box marked “immobilizer” or “134.2 kHz”. Remove immobiliser ECU from the car and open it. Find 93C66 EEPROM in DIP package. Use A5 or A4 adapter and follow CarProg instruction to program transponder key. Short quartz resonator for in-circuit EEPROM programming or remove 93C66 from immobiliser board. All right reserved www.codecard.lt 2 S4.2.2 Lexus immobiliser system with transponder antenna and AMP unit on the ignition key and motor ECU. Used in 1999 – 2003 Lexus cars. Transponder information is stored in motor ECU. Remove motor ECU from the car, open it and find 93C56 EEPROM marked IC900 Use A6 or A4 adapter and follow CarProg instruction to program transponder key. Short quartz resonator for in-circuit EEPROM programming or remove 93C56 from ECU board. S4.2.3 New Lexus cars with Texas Crypto transponder (4D by Silca). Transponder key is stored in separated immobiliser unit marked “ECU IMMOBILIZER”. Remove immobiliser ECU from the car, open it and find 93LC66 SMD EEPROM. All right reserved www.codecard.lt 3 All right reserved www.codecard.lt 4 Use only original factory key. With Silca 4D transponder car will not start. Use A6 or A4 adapter and follow CarProg instruction to program transponder key. Short quartz resonator for in-circuit EEPROM programming or remove 93C66 from immobiliser board. All right reserved www.codecard.lt 5
Similar documents
S4.4 CarProg Motorola HC912 and 9S12
Second 4 symbols is always letter + digit + digit + letter: this is processor maskset or
encrypted processor type. All processor marking can by custom made, like “FORD
S2234234” or SC2323454 but al...
CARPROG VAG Airbag manual
You can install sensor back to the car or connect this sensor on the table. Some cars don’t
have K-line, in this case use connection on the table.
Use this wiring:
Airbag sensor: K-line = pin 67 (c...
S4.1 CarProg TOYOTA immobiliser manual
S4.1.9 Toyota Avensis or Corolla immobiliser system with transponder antenna and AMP unit
(on the ignition key lock) and motor ECU. Transponder 4C. Are two very similar immobiliser
types – with Tex...
