CT-Otoplasty

Transcription

CT-Otoplasty
www.ceotronics.com
CT-Otoplasty
•H
ints for the perfect individual ear mold
CT-ClipCom
PPE
Certified hearing
protection to
EN 352
auditory canal shaped/formed to short
auditory canal shaped/formed inaccurate
auditory canal squeezed
ear mold too flat
Cymba shaped/formed incomplete
Antitragus as well as auditory canal
shaped / formed incomplete
Soft silicone
ear adapters
Shore
hardness: 40
CT-ClipCom BoomMike and CT-ClipCom EarMike
The perfect ear mold
Certified as personal protective equipment (PPE)
CT-ClipCom offers both features. It enables flawless communication, complies with EU directive EN 352-2:2002 and is approved for use as personal protective equipment. Depending on requirements one can use, either a lamella-shaped rubber earplug
offering excellent wearer comfort or an ear piece molded from
silicone (otoplastic) to match an individual ear form. Each can
easily clipped on (see picture above), making the communications system personnel-independent. If personnel changes, only
the CT-ClipCom earplug or ear piece needs to be swapped (also
relevant in terms of good hygiene). This means that it is not necessary to purchase a complete communication system for each
team member.
Guarantee for the best fit of individually molded (personalized)
otoplasty such like:
2 I CT-Otoplasty
- hearing protection
- headsets
For the perfect customization of these individual products an individual imprint of the ear will be made. Therefore, the auditory
canal as well as the complete choncha are homogeneously and
non-porous filled with silicone. The transitions from the choncha
to the outer side need to be visible at the silicone mold.
The pictures above each display two molds – one good and one
bad – to show the essential deformity and mistakes for easy
identification.
Hint:
Slightly open the mouth (approximately the widths of a finger)
during the process of taking the imprint. You must not speak nor
chew nor move your mouth until the imprint material hardened.
Please avoid inaccuracy during the molding procedure as this is
the cause for non-fitting molds at the end.
CT-Otoplasty I 3
CeoTronics AG
Audio • Video • Data Communication
Adam-Opel-Str. 6
63322 Rödermark (Germany)
Tel.:
+49 6074 8751-0
Fax:
+49 6074 8751-265
E-Mail: sales@ceotronics.com
Web:
www.ceotronics.com
© CeoTronics AG, December / 2015 • Subject to modifications and errors. Pictures similar.
www.ceotronics.com