2003-2006 Honda Accord iPod Installation Using the Blitzsafe HON

2003-2006 Honda Accord iPod Installation
Using the Blitzsafe HON/AUX DMX V.2X and an RCA to 1/8" Phono adapter cable
The installation procedure listed here was performed on a 2005 Honda Accord EX V6 without a
navigation system. The vehicle includes factory XM Satellite Radio, 6-disc in-dash CD changer,
and dual climate controls. Even though the vehicle used was a 2005 model year this procedure
should also work on 2003, 2004, and 2006 model years as well. However, I offer no guarantee that
the installation will work on your specific vehicle. I'm only assuming that it will work due to
similarities in vehicle manufacturing among these model years. Certain steps are specific to an
Accord EX, for instance you may not have to remove the seat heater switch connections on your
vehicle. I'm unsure how this installation will work on navigation equipped vehicles or if it will
even work at all. Use your own discretion and judgment. I am not responsible for damage that may
occur to yourself or your vehicle. If you don't feel comfortable or confident with disassembling the
center console and disconnecting vehicle wiring then I suggest you not perform this procedure.
Instead you should visit a local car audio installation professional. I too was hesitant with
performing this procedure for the first time, but as long as you take your time and have patience
you'll do just fine. I tried my best to make this procedure as detailed and informing as possible.
This installation procedure should be used as a guide only.
This installation may not be suitable for all individuals. I'm merely giving my personal account on
how I performed the installation for my own needs. For instance, I chose to connect an iPod to my
factory radio by using the Blitzsafe HON/AUX DMX V.2X. However, you might want to connect
another type of MP3 player or audio device. You also might choose to route the cable a different
way. For this application I chose to route the audio cable through the center console storage bin by
drilling a hole in the back of the bin. Make your own changes where necessary when performing
the installation procedure detailed below.
For questions or comments about this installation email justin@beaufordbuddy.com
http://www.beaufordbuddy.com/ipod_install_1.htm
TOOLS AND MATERIALS THAT YOU WILL NEED:
- Blitzsafe HON/AUX DMX V.2X (found here - opens in new window / tab)
- RCA to 1/8" Phono adapter cable (can be found at most electronic retailers or here - opens in new
window / tab)
- Flat tip screwdriver
- Cross tip screwdriver ("Phillips Head")
- Power drill (optional, depending on how you want to route the audio cable)
- 11/16" spade drill bit (optional, depending on if you'll be using the drill or not)
- 1/2" rubber grommet (optional, depending on if a hole will be drilled or not)
- Electrical tape
- Cable ties ("Zip ties")
INSTALLATION PROCEDURE:
At this point you should reverse steps 1-14 to reassemble the center console area. Ensure that all
electrical connections are reconnected (seat heater switches and 12V power outlet). Be careful
when replacing the storage bin, trim, and console sections. Don't use excessive force as you may
damage the retaining clips that properly seat each section.