Model SA Airless Palletized Striper

Model SA Airless Palletized Striper
Model SA
Airless Palletized Striper
Weight: 1,260 lbs.
Paint Capacity: 60-120 lbs
Bead Capacity: 350-500 lbs.
Operators Required: 1 or 2
Palletized stripers will ft in a pickup truck or on the back of
a fatbed truck. These units can have either fxed carriages
to be operated from the cab of the truck, or steerable
carriages to be used as a two-man operation.
This Model Features:
Lightweight Design—1,260 lbs. allows plenty of payload
20hp Kohler Engine
Pressure-compensating piston hydraulic pump
Control panel
Solenoid enclosure
The control panel is mounted at the
rear/center of the striper to allow easy
access from either side of the machine.
Paint and bead pressure adjustments
can be made on the fy. Solenoids are
mounted in a protective enclosure.
100% waterborne paint compatibility
8.6 GPM airless paint pump
Complete drum-to-gun recirculate system
350 lb. capacity bead system (500 lb. optional)
Gun carriage transport position
Lifting eyes at all four corners
Well balanced layout of the machine
1 of 2
assures an even load
Model SA Airless Palletized Striper
The paint pump siphons paint directly from
the drum. The stainless steel lid assembly
has a gasket and clamps to assure a tight
seal. A hand agitator is standard but a
hydraulic motor is available.
Also, (as seen on the right) the paint
flters can be extended past the rear of
the truck for easy cleaning with no drip
on the machine.
The paint pump piston is covered to keep
out dirt and contaminates. The flters are
mounted at the rear of the machine to
help keep it clean during flter service.
Solenoids are mounted in a
protective enclosure to keep
them out of the weather.