Onboard Preamp Wiring Diagram – Prewired Kit
Transcription
Onboard Preamp Wiring Diagram – Prewired Kit
PreampHarnessBoxInsert:Letterhead 7/17/13 1:09 PM Page 1 SADOWSKY GUITARS LTD. 2107 41ST AVENUE • 4TH FLOOR LONG ISLAND CITY, NY 11101 — PHONE (718) 433-1990 FAX (718) 433-1993 Sadowsky Onboard Bass Preamp Master Volume / Blend / Vintage Tone / Treble and Bass Boost Pull up on tone knob for true bypass of preamp We recommend installation by a professional guitar technician. On a typical J-style bass, the output jack needs to be moved to the side of the body and a battery compartment must be installed in the rear of the bass. System operates on a single 9V battery. No additional headroom is gained by using 18 volts. For other configurations, remove the plate. Pots can be configured for a 4-in-line or a diamond pattern. Threaded potentiometer bushing length is 3/8" for rear control cavity installation. SPECIFICATIONS Frequency Response Power Source Battery Life Bass Control Treble Control Total Harmonic Distortion Input Impedance Output Impedance 5Hz to 20.9KHz (+/– 1.5db) One 9V Battery 870 Hours* +13db Boost @ 40Hz +13db Boost @ 4KHz 0.18% @ 1KHz 1 Meg Ohm 1K Ohm We highly recommend the BATT-O-METER for easy testing of battery level via the output jack. We recommend changing the battery when the voltage reaches 7V. *NOTES: Battery will drain whenever a cable is inserted into the input jack. Switching to bypass will not conserve battery life. Under normal use, you should expect about six months of battery life. The Vintage Tone Control operates in both active and passive modes. www.sadowsky.com/store/batt-o-meter.html www.sadowsky.com info@sadowsky.com REVISED 07-17-13