Civic/Integra EG/EK/DC2/DB8 Front subframe collars

Civic/Integra EG/EK/DC2/DB8
Front subframe collars
Tools needed: Breaker bar, Ratchet, 17mm &19mm sockets Copper grease •
Jack up and support the front of your car on the body (not suspension
arms/wheels!) with axle stands.
•
Take a look at the collars in your kit. There should be 2 pairs with
different wall thicknesses.
•
Locate the four main bolts holding on the subframe (one either side
from the pics, shown in red). Slacken the compliance bush bolts as
well (shown in yellow).
•
Remove one bolt and place a collar on it, then screw it in finger
tight. Fit the thicker-walled collars first.
•
Once you have all four bolts screwed back in finger tight then tighten
them all up. The collar may seem slightly tight going in, this is normal
but double check you have not got the collars the wrong way round
(thick walled vs thin walled) if you have any doubts.
•
Lower your car back down and take it for a test drive. There is a
small chance that your tracking will need to be reset, but once set it
should never need re-doing as your subframe is now fixed in place.
If you have any questions about this or any of our other products please email us on info@tegiwaimports.com and we will be happy to help.