t-top stand-off - Stryker T-Tops

T-TOP STAND-OFF
INSTALLATION GUIDE
NOTE
STAND-OFF’S PROVIDE ADDITIONAL SUPPORT
FOR YOUR T-TOP. THEY CONNECT THE LEGS OF
THE T-TOP TO THE CENTER CONSOLE.
INSTALLATION SUPPORT
1
GUIDE#: STANDOFF-001
PARTS LIST (PER STAND-OFF)
1x
1x
1x
1x
1x
1x
1x
2
GUIDE#: STANDOFF-001
EXPLODED VIEW
STEP 1
FOR MAXIMUM SUPPORT IT IS
RECOMENDED THAT THE STANDOFF’S ARE MOUNTED IN THIS
AREA.
3
IT IS IMPORTANT TO MOUNT
THE STAND-OFF TO AN AREA
OF THE COSOLE THAT IS
FLAT, SMOOTH AND PERPENDICULAR TO THE STAND-OFF
(PARRALEL WITH THE TOWER
LEGS).
GUIDE#: STANDOFF-001
**IMPORTANT**
MAKE SURE YOU HAVE ACCESS TO THE INSIDE OF THE CONSOLE IN
THE MOUNTING AREA SO THAT YOU CAN TIGHTEN THE STAND-OFF
NUT WITH A WRENCH OR SOCKET SET.
STEP 2
FRONT VIEW
MEASURE WIDTH FROM THE MOUNTING
SURFACE ON THE CONSOLE TO THE
CLOSEST SIDE OF THE T-TOP TUBE.
MARK MOUNTING
LOCATIONS.
**IMPORTANT**
BE SURE TO TAKE THIS MEASUREMENT IN
THE DESIRED MOUNTING LOCATION.
STEP 3
MEA
SURE
CUT
LE
FROM NGTH = T
H
TUBE THE INSID E MEASU
REME
TO TH
E OF
N
TH
OF TH
E
E CO MOUNTIN E T-TOP T
NSOL
G SU
E.
RFAC
E
MARK THE
CUT LENGTH
4
NEVER TRIM THIS END TO LENGTH.
THIS CURVED SURFACE IS USED TO
MOUNT TO THE T-TOP TUBE.
GUIDE#: STANDOFF-001
STEP 4
CUT THE TUBE ALONG THE MARKED LINE.
A HACKSAW IS RECOMEND.
DEPENDING ON THE REQUIRED ANGLE
A CUTTING JIG MAY BE HELPFUL.
STEP 5
DRILL HOLES AT MARKED POSITIONS ON
BOTH THE T-TOP AND THE CONSOLE.
5
CONSOLE
T-TOP
**IMPORTANT**
MAKE SURE THE HOLES ARE STRAIGHT AND
ALIGNED SO THAT THE THREADED ROD
CAN PASS EASILY THROUGH BOTH.
GUIDE#: STANDOFF-001
STEP 6
ASSEMBLE PARTS IN THE
SAME ORDER AS SHOWN
IN THE EXPLODED VIEW.
STEP 7
6
CONSOLE
T-TOP
2 X WRENCH OR SOCKET
WILL BE REQUIRED TO
TIGHTEN NUTS.
REPEAT INSTALLATION PROCESS
ON BOTH SIDES OF THE T-TOP.
GUIDE#: STANDOFF-001
NOTE: IF YOUR T-TOP REQUIRES ADDITIONAL STABILITY
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT
FOR FURTHER RECOMENDATIONS.
Questions?
www.strykerttops.com
7
GUIDE#: STANDOFF-001