- Hydro One Marketing Sdn. Bhd
Transcription
- Hydro One Marketing Sdn. Bhd
User Manual Hydro One WDB-Series Outdoor POE Water Filter Hydro One Marketing Sdn. Bhd. (648758-P) 32, Jalan Bukit Rawang Putra 6, Taman Bukit Rawang Putra, 48000 Rawang, Selangor Darul Ehsan, Malaysia. Tel Fax Email Website : : : : +603 - 6092 0120 +603 - 6092 0305 equiry@hydro1.com.my www.hydro1.com.my Parts Identification Operation & Maintenance of Water Filter User should identify the main components and other relevant accessories of the Water Filter prior operation & maintenance. Refer Diagram 1 below: The Water Filter will be functioning in 3 different mode of operations, mainly Filter, Backwash & Rinse (Refer Diagram 2). The water filter is to be operated by the 3-way Multiport Valve and its relevant Ball Valves (Refer Part 1, 2 & 3 in Diagram 1). 1 2 3 6 4 7 5 DIAGRAM 1 FRONT VIEW REAR VIEW 1. Multi port valve To divert the water flow in-and-out of the water filter in according to the mode of operation. 2. Inlet Ball Valve Normally open and is used to isolate the water flow into the water filter. 3. Outlet Ball Valve Normally open and is used to isolate the water flow out from the water filter and returning to household water supply. 4. By Pass Valve To by pass the water filter during major maintenance/ service without interrupting the water supply to the house. 5. Backwash piping To discharge filtered sediments to the nearest drain hole. 6. Inlet Piping Unfiltered water supply from main into the water filter 7. Outlet Piping Filtered water supply from filter system back into the household pipind DIAGRAM 2 Filter Mode funtion: To let unfiltered water to flow from top to bottom through the filtration media bed and sediments will be filtered. Filtered water will be distributed to Outlet through the inner riser pipe. Backwash Mode funtion: To reverse the water flow in order to discharge the filtered sediments out from the water filter and discharge to Drain. Rinse Mode funtion: It has the same water flow as Filter mode, however, instead of distribute the water to outlet, it will be discharged to drain. This is to ensure the water quality is clean again after backwash is performed before switching back to Filter mode.