instructional manual

INSTRUCTIONAL MANUAL
T S O V E T. C O M
2
REGISTRATION
To ensure that we are able to provide you with immediate attention and prompt
service, register your TSOVET watch online. By doing so, our staff is able to
assist you with any warranty claims and concerns.
Registration instructions are available on our website. Please visit:
TSOVET.COM
T S O V E T. C O M
3
YOUR WATCH IS EQUIPPED WITH EITHER A SCREW DOWN CROWN
(PICTURED) OR A STANDARD CROWN (PAGE 10).
T S O V E T. C O M
4
ABOUT THE SCREW-DOWN CROWN
Specific models feature a screw-down crown; this component helps prevent
moisture infiltration. Always be certain that your crown is completely screwed
down before entering any environment or before undertaking any activities
where moisture is present. Never unscrew your crown while in any environment
where moisture is present.
T S O V E T. C O M
6
OPERATING THE SCREW-DOWN CROWN
In order to pull the crown out to the first or second locking position, it must first
be unscrewed.
To open the crown, simply turn the crown counter-clockwise 4 to 5 turns.
To close the crown and screw it down, push it in while turning clockwise; lightly
finger-tighten the crown. BE SURE TO NOT OVER-TIGHTEN THE CROWN!
The precision threading of your TSOVET screw-down crown, in part, provides
effective moisture resistance. By over tightening the crown, the materials and
related components (seals & gaskets) can be damaged, resulting in reduced
moisture resistance.
T S O V E T. C O M
7
CROWN POSITIONS
The TSOVET screw-down crown has four positions:
One: Screwed down (closed): The crown of your watch is ready to wear and
is moisture resistant.
Two: Unscrewed (open): The crown of your watch is unscrewed and is not moisture resistant.
Three:Unscrewed, with crown pulled out to the first notch (open): to set
the hour hand. The crown of your watch is unscrewed and is not
moisture resistant.
Four: Unscrewed, with crown pulled out to the second notch (open): to set
the date. The crown of your watch is unscrewed and is not moisture
or resistant.
T S O V E T. C O M
8
CALENDAR SETTING INSTRUCTIONS
SETTING YOUR CALENDAR
The date will automatically change to the following day at midnight. It is best to set
the time during the calendar jump phase which is between 10:30pm and 11:59pm.
CROWN POSITION 1:
Operating position, watch runs
CROWN POSITION 2:
First Stop - Quick change of the date (clockwise)
watch runs
CROWN POSITION 3:
Second Stop - Hand-setting, watch stops. Save 90% energy - when the stem is pulled out.
T S O V E T. C O M
9
OPERATING A TSOVET WITH A STANDARD CROWN
The TSOVET standard crown has either 2 or 3 positions:
(1): (Closed): The crown of your watch is ready to wear.
(2): (Open): The crown of your watch is open and is not moisture resistant. Turn clockwise or counter clockwise to set the time.
(3): (Open): Specific models are equipped with a standard crown and may be fitted with a calendar/date function. With the crown pulled out to the second notch, turn clockwise to set (reference page 9).
T S O V E T. C O M
10
OPERATING AN AUTOMATIC TIMEPIECE
(1): Manually wind the watch in a clockwise motion 12-15 turns. It
is impossible to feel full winding in the automatic watch, but there is no way to break the mainspring as well. Do not wind with force as the automatic device can be used up untimely.
(2): Swing it from side to side in a horizontal position for about 30 seconds and wear the watch. The rotor will continue to wind the watch as you wear it.
(3): Setting of time/calendar - adjust the date on your watch only when the hour hand is below the 2 and 10 markers.
*Power reserve of 38 hours +/-.
T S O V E T. C O M
12
OPERATING JPT-TS44 CHRONOGRAPH
(1): Press button “A” to start the stopwatch.
(2): The stop watch can be started and stopped each time button “A” is pressed.
(3): Pressing button “B” resets the stopwatch and stopwatch minute and second hands return to zero.
*Chronograph will stop automatically after running continuously for 30 minutes.
T S O V E T. C O M
13
CHRONOGRAPH RESET (INCLUDES AFTER REPLACING BATTERY)
This procedure should be performed when the stopwatch second & minute
hands do not return to the zero position.
(1): Pull the crown out to the 2nd Click Position.
(2): Press button “A” to move the chrono second hand forward.
Press button “B” to move the chrono second hand back.
* The chrono minute hand is synchronized with the chrono second hand.
* The chrono second hand can be advanced rapidly by continuously pressing button “A” or “B”.
(3): Once both hands have been zeroed, set the time and return the crown to its normal position.
T S O V E T. C O M
14
OPERATING SVT-DE40 CHRONOGRAPH - SETTING THE TIME
(1): Pull out the crown to second stop.
(2): Turn the crown until you reach the correct time.
(3): Push the crown back to operating position.
MINUTE
HAND
HOUR
HAND
SECOND
COUNTER
MINUTE
COUNTER
SECOND
HAND
*In order to set the time with the exact second, (1) must be pulled out when the
second hand is in position «60». Once the hour and minute hands have been set,
(3) must be pushed back into operating position at the exact second.
T S O V E T. C O M
16
OPERATING SVT-DE40 CHRONOGRAPH - BASIC FUNCTION
(1): Start: Press button “A”.
(2): Stop: To stop the timing, press button “A” once more.
(3): Zero positioning: Press button “B”. The chronograph hands will be reset
to their zero positions.
(4): If second hand and sub-minute dial (a 9 position) do not align refer to
adjusting the chronograph hands to zero position.
T S O V E T. C O M
17
OPERATING SVT-DE40 CHRONOGRAPH - ACCUMULATED TIMING
(1): Start: start timing.
(2): Stop: stop timing.
(3): Restart: timing is resumed.
(4): Stop: the accumulated measured time is shown.
(5): Reset: the chronograph hands are returned to their zero positions.
*Following (4), the accumulation of the timing can be continued by pressing
button “A”. (Restart / Stop, Restart / Stop, ...).
T S O V E T. C O M
18
OPERATING SVT-DE40 CHRONOGRAPH ADJUSTING THE HANDS TO ZERO POSITION
Example: One or several chronograph hands are not in their correct
zero positions and have to be adjusted (e.g. following a battery change).
(1): Pull out the crown to position second stop (all chronograph hands are in
their correct or incorrect zero position).
(2): Keep button “A” and button “B” depressed simultaneously for at least 3+
seconds (the second counter hand rotates by 360º – corrective mode is activated).
continues on next page...
T S O V E T. C O M
19
(3): Adjusting the chrono second counter hand (9 position sub-dial)
Single step: press button “A” x short.
Continuous: press button “A” x long.
(4): Adjusting the next hand
Press button “B”.
Adjusting the chrono minute counter hand
Single step: press button “A” x short.
Continuous: press button “A” x long.
(5): Returning the crown to operating position. Termination of the
chronograph hands adjustment (can be carried out at any time).
T S O V E T. C O M
20
DIVERS SCALE
Located on the turning bezel of the SVT-DW44 dive watch.
Unidirectional Rotating Bezel: The most important feature of any divers watch
and an essential part of every divers equipment is the diving ring. This is a
rotating bezel around the dial or the crystal. It is divided into minutes and often
has a triangular fluorescent marking at 12. Before divers take to the water, they
have calculated the time they can spend under water. The diving time depends
on the depth and the amount of oxygen taken down. When a diver has 45
minutes of air and enters the water at 14:00 hours, the triangular marking has
to be set 45 minutes later, in this case at 14:45. The minute hand has a similar
triangle as the diving ring. When both markings meet it is time to surface
because air is running out.
TACHOMETER
Specific models feature a Tachometer, or Tachymeter, which is simply a function
on a watch that allows the user to measure speed.
A Tachometer is a feature found on some chronograph watches that measures
the speed at which the wearer has traveled over a measured distance. In
matchmaking, it is a timer or chronograph with a graduated dial on which speed
can be read off in kilometers per hour or other units of distance.
T S O V E T. C O M
21
SIZING YOUR WIRE MESH BAND
(1): Lay the watch / band on a flat smooth and soft surface.
(2): Insert the screwdriver into the rectangular opening and apply pressure
to lift the adjustment plate (1, 2, 3)
(3):
Once the adjustment plate is lifted, then slide the clasp to your designated
adjustment slot (3, 4, 5)
1.
2.
3.
4.
T S O V E T. C O M
22
SIZING YOUR WIRE MESH BAND
(4): Adjustment grooves are small parallel indentations on the underside of
the mesh (5)
(5): Find the adjustment groove suitable to your wrist size and push down on
adjustment plate to secure (6 & 7)
5.
6.
7.
T S O V E T. C O M
23
CLOSING THE CLASP ON A WIRE MESH BAND
(1): Connect the locking clasp to the clasp bar (1 & 2)
(2): Fold the locking clasp over and press firmly until the clasp clicks in
firmly (2 & 3)
1.
2.
3.
4.
T S O V E T. C O M
24
FIVE YEAR LIMITED WARRANTY / LIFETIME BATTERY REPLACEMENT
Your TSOVET watch is backed by a five year limited warranty and lifetime
battery replacement with proof of purchase.
TSOVET guarantees this watch to be in working condition and warrants the
dependable functioning of its entire movement for the period of five years from
the date of purchase. If your watch malfunctions within the five year period of
warranty, TSOVET will repair the defect.
PLEASE EMAIL INFO@TSOVET.COM FOR FURTHER INSTRUCTIONS OR
VISIT TSOVET.COM
After the five years from the date of purchase, the standard cost of any repair
will be charged, whether or not the replacement part(s) are supplied under the
terms of the warranty.
T S O V E T. C O M
26
WHAT THIS WARRANTY DOES NOT COVER:
Internal or external damage resulting from an unscrewed crown, accidents,
mishandling or abusive use (i.e., knocks, dents, crushing, contact with
moisture—including, but not limited to, “hot tubs,” “jacuzzis,” or “saunas,” etc.),
or the consequences of normal wear and aging of the watch (i.e., scratches
and abrasions to the crystal, case, metal band, buckle, leather); unauthorized
alterations, tampering, manipulation, mistreatment, or modification through the
addition or substitution of parts or accessories not supplied by TSOVET; repairs
made by unqualified third-parties or non- warranted dealers; and the use of
batteries other than those prescribed by TSOVET.
WARRANTY DISCLAIMER
TSOVET strongly recommends against introducing your watch to environments
where both heat and moisture are present (e.g., “hot tubs,” “jacuzzis”, or
“saunas”). The combination of heat and moisture can adversely affect the seals
and gaskets in your watch. If your crown is not closed properly, water will
penetrate the case. Failing to adhere to the aforementioned precaution voids
your warranty.
T S O V E T. C O M
27
SHIPPING RESTRICTIONS
If your TSOVET watch has an after market exotic strap (e.g., alligator, crocodile,
snake, ostrich, fish/eel), it must be removed prior to returning the watch to us.
U.S. Government Fish and Wildlife Service regulations prohibit the shipment
of exotic species, in whole or part, without proper documentation. Remove any
exotic straps and send only the watch case. Shipping restrictions do not apply
to genuine leather, synthetic, embossed, and metal straps.
IMPORTANT
All warranty work must be mailed to our headquarters post-paid. Shipping charges
are the responsibility of the owner (for return shipping, include a $20 money order
payable to TSOVET, or contact Customer Service via www.tsovet.com).
T S O V E T. C O M
28
For repair requests, contact Customer Service via email at info@tsovet.com for
a Return Authorization Number.
Ship your watch via UPS, USPS, FED EX, or DHL, and insure your shipment
(do not return the gift box when returning your timepiece for service. It will be
returned C.O.D.).
We do not ship to P.O. Box addresses.
Include a copy of your warranty card and receipt showing date of purchase.
Include a copy of the malfunction report (supplied by Customer Service) with
your return. Include your name, phone number, address, and email address.
If your TSOVET watch is not under warranty, you will be responsible for all repair
costs (repair cost schedule available at www.tsovet.com). All out-of warranty
repairs require pre-payment (include a money order payable to TSOVET or prepay online with a credit card).
T S O V E T. C O M
29
A M E R I C A N D E S I G N - N E W P O R T, C A