ez cattle brush with oiler

E.Z CATTLE BRUSH WITH OILER
Tt'ris apparatus can effectively be used against lice and against flies.
It is not advisable to force the animals to pass under the brushes at fixed times. The apparatus
functions best when placed in a loose housing barnyard or pasture where the animals can
walk freely around and where it can be used by the animals when needed.
The animals have to get used to the brushes
before the reservoir is filled.
Flies: lf cattle
used the brush twice a day or
more, reduce liquid flow to 20 drops a
Lice:
minute.
i
Cows that are troubled by lice will use the
brushes and in this way apply insecticides
on their skins.
The speed with which the liquid should
pass is approx. 60 drops per minute.
Repeat this process within two to three
weeks, if necessary.
One apparatus can be used for approx.
50 to 75 cows.
How to change the speed with which the liquid
through the brushes:
. Adjust the tap
. Push up on one nipple stem
. Time the drops & set as necessary to the size of
your herd & the daily use the brush
. if necessary adjust and check again
passes
Check label of any insecticides.
Height: Mount the unit so that the horizontal
brush reaches the back of the animal.
Recommended height for holstein dairy is approx. 50-54" underneath the
horizontal brush, depending of course on height of your cow
When installed in the right place and when welt adjusted, the apparatus
is very effective and uses a minimum of insecticides.
ASSEMBLING DIRECTIONS
1 B-
"g -cr- zontat brush frame to vertical brush frame and guide plastic oil tubing and bolts through holes in vertical frame.
',bber O-ring to keep bolts in slot).
,Use
.
BE SI.IRE BRISTLES ON HORIZONTAL BRUSH POINT STRAIGHT DOWN
2 =aste- horizontal frame to vertical frame with lock washers and nuts (Tightly using deep socketl!). Run oil
3 Faster tank frame to vertical frame using same bolts and flat washers with lock nuts.
tubing upwards
4 raster prastic oil tubing to tap.
Be sure
to fasten the cattlebrush with oiler secure to a solid structure
4. Horizontal Brush
5. 5pnng
6. Vertical Brush
7. Nipple Block
8. Nipple Stem
9. Oil Tube Connector
10. Nipple Base
11. O-washer
12. Nipple Stem
13. Valve Spring
14. Screw
15. Vert. Brush Frame
16. Horiz. Brush frame
17. Spring Tube
19. Nipple Unit Frame
20. Steel Tank
21. Tap for Steel Tank
22. Steel Tank lid
23. Plastic Oil Tubing
I,LiJ
14
13
12
11
10
TO REPLACE NIPPLE STEMS:
.
.
.
Remove nipple unit frame (#19) from horizontal
brush frame (#15) by taking out the bolts.
Remove nipple block and unscrew each nipple
base (#10).
Remove screw (#14), spring (#13), nipple stem (#12)
and o-washer (#11) from nipple base and replace o-
washeL nipple stem and spring in that order.
. Return screw
(#14) to the top.