Tek vest

OR
12 NOV 13
For technical support contact steve@tekrider.com
Two levels of coverage to offer you
Whether you ride dirt or snow, TekVest
can now offer you two coverage concepts;
Tek4D for traditional 360 degree coverage!
( Meets ISR regulations)
Or
The all new Tek3D for 270 degree coverage!
(Do not meet ISR regulations)
12 NOV 13
contact Steve at steve@tekrider.com
Do not meet ISR
regulations
12 NOV 13
Meets ISR regulations
For technical support contact steve@tekrider.com
Tek4D for traditional 360 degree
coverage!
Tek4D coverage = sides + shoulders + front + back
 All TekVest models made before 2013 are Tek4D
Only Tek4D models are approved for
ISR sanctioned snowmobile racing.
* note: some disciplines require arm pads to meet rules.
12 NOV 13
For technical support contact steve@tekrider.com
13/11/2013
contact Steve at steve@tekrider.com
These Tek4D models meet ISR regulations
*optional arm pads required for some ISR disciplines.
Rally
Sold with permanent arm pads
TrailPro *
SX ProLite
SuperSport *
FreeStyle*
Sold with permanent arm pads
12 NOV 13
For technical support contact steve@tekrider.com
These Tek4D models meet ISR regulations
*optional arm pads required for some ISR disciplines.
Yamaha*
Sled Diva *
2 x Polaris models *
3 x Arctic Cat models *
12 NOV 13
KLIM*
509 Backcountry *
For technical support contact steve@tekrider.com
These Tek4D models meet ISR regulations
NOTE TO ALL RACE PROMOTERS
1. TekVest has made many custom models over
the years.
2. They may be hard to identify.
3. They should all have TekVest inside labels and
outer rubber labels.
4. Any vest which does not have either of these
logos is likely not a TekVest.
5. When in doubt send us a picture and we can
verify it for you . steve@tekrider.com
12 NOV 13
For technical support contact steve@tekrider.com
The all new Tek3D for 270 degree coverage
Tek3D coverage = sides + shoulders + front
 The all-new Tek3D back design is compatible with your
existing back pack, hydration pack or avalanche pack.
Compatible with all current neck braces.
 The traditional back panel has been modified to
increase air gap and airflow and reduce operating
temperatures under pack. * Does not meet ISR specs
 Designed specifically for the mountain/backcountry
snowmobiler, or off-road ADV/Enduro rider, who stand
up while riding most of the time. Riders will appreciate
taller cut.
 This is now the lightest TekVest ever made & coolest
running!
12 NOV 13
For technical support contact steve@tekrider.com
Tek3D for 270 degree coverage
Two new Tek3D models to choose from in 2014/15
The
CrossOver
The
OutBack
Both models are
neck brace ready!
These 2 models
DO NOT meet
ISR regulations
12 NOV 13
For technical support contact steve@tekrider.com
SINCE 1996
Each TekVest is proudly made in North America
for the best fit and performance!
All major armor and fabric components come from NY, PA, NJ, GA, ON & QC
Contact Steve Brand for technical support
Cell/text 416 271 6844
steve@tekrider.com