78/4 Moo 6, Sukhumvit Road., Ban Chang, Rayong 21130 Thailand

Transcription

.
78/4 Moo 6, Sukhumvit Road., Ban Chang, Rayong 21130 Thailand: Tel. +66 038 880632 Fax. +66 38 880631
E-Mail: info@dacon-trading.com Website: www.dacon-trading.com
MILAN 2.0
POWER
A-029
Weight: < 3 kg.
Standard: EN 341 KIA, EN1496, ANSI Z359 4
The MILAN 2.0 POWER is a special version of the
MILAN 2.0 HUB that additionally can be powered
electrically. • Off grid thanks to lithium-ion
rechargeable batteries • Max. Rappelling weight
250 kg • Distances to 60 m at 100 kg with 1 battery
charge • Changing batteries on the hanging rope is
easily possible • If there is a device fault or low
battery charge, emergency operation is ensured
through the hand wheel. Note: The MILAN 2.0
POWER may only be used with the devices that are
also provided by SKYLOTEC! The modified,
rechargeable battery device, specially developed
for MILAN 2.0 Power can be easily and quickly
adapted and enables faster rappelling up of an
accident victim over longer distances or rappelling
yourself up
SEAL PAC
SET-SEAL-PAC-LTG-L
extended warranty
interval 8 years
SEAL PAC
SET-SEAL-80
extended warranty
interval up to 10 years
ARG 51 FORMOTION
G-0051
RESCUE PRO 2.0
G-1083-AL
Special variants
available: X-Pad,
Windenergy and
Offshore
Special variants
available: X-Pad,
Windenergy and
Offshore
Weight: 2.6 kg. XS-M: L-XL
Standard: ANSI Z359.1:2007, ANSI Z359.3:2007, CSA
Z259.10-12-A/D/P
Rope Access at its best. The concept inspiring the design
of this harness was for rotor blade inspection on wind
turbine generators Well-known members of the leading
rope access associations participated in the development
of this “state of the art” rope access product.
SKYBOARD
G-0205
Weight: 1.8 kg.
PASSO TRI
H-137-TRI
Weight: 90 g.
Standard: EN 362, EN
12275, UIAA 121
Weight: 3.09 kg. XS-M: L-XL
Standard: ANSI Z359.1:2007, CSA Z259.10-A/L/P:2006,
GB 6095:2009, GOST R 12.4.205:1999, GOST R
12.4.224:1999
Decades of experience have gone into the ARG 51
FORMOTION, making it an ideal industrial fall-arrest
harness. It meets numerous international standards and
can therefore be used worldwide. 1. It is easy to put on,
thanks to click fasteners. 2. The central chest eyelet can
be adjusted perfectly, can always be centred thanks to four
different buckles, and sits close to the body. This
increases the wearing comfort and reduces fall-back risk.
3. The ring at the side allows the four straps to move
independently of each other. This makes climbing and
bending easier. 4. The light and flexible back support
provides maximum wearing comfort. 5. The positioning
rings on each side can be folded back, making the descent
into narrow manholes easier.
STANDARD ROLL
H-067
Weight: 235 g.
Standard: EN 12278,
32 kN
X-trem Dynamic
R-052
Standard: EN 892
Diameter: 11 mm. 9 kN
SKYSAFE PRO FLEX Y
L-0559-1, 8
Weight: 1.81 g.
Standard: EN 354:2010 EN 355:2002
ONE4ALL - The SKYSAFE PRO Revolutionary, new, patented
energy absorber with the large weight range from 50 - 140kg (110
- 310 lbs.) that always withstands a maximum impact of less than
6 kN at a maximum absorber length of 1.75m (5.7 Feet). The final
impact resistance of 22 kN, also in the absorber, before AND
after a fall is exceptional as well. SKYSAFE PRO furthermore
meets the most relevant international standards in one SINGLE
product. UNIQUE: The built-in, adjustable RESCUE LOOPS! As
a result, rescuers need not set up a rescue system and hereby
save precious time in a rescue! Available in four versions with
different carabiner combinations: I-rope, Y-rope, I-rope tie-back,
Y-rope tie-back.
Load-distance diagram of the revolutionary
SKYSAFE PRO
Load-distance diagram of a usual textile energy
absorbing element
ERGOGRIP SK12
L-0259-1, 5
Length: 1.5 m, 2
Weight: 1.01 g.
Standard: EN 353-2: 2002EN 358:1999 Holding ropes are for getting into the right
working position. The core-sheathed
ropes used by SKYLOTEC can withstand
extreme edge loads, are resistant to
abrasion, remain soft in damp conditions
and feature a long service life. It is an
extremely simple matter to adjust the
Ergogrip
range
with
self-locking
karabiners with one hand
D-BOLT
AP-058
Weight: 624 kg.
Standard: EN 795-A
CEN/TS: 16415-2013
3 Person
D-BOLT-STAINLESS
AP-063-GPS
Weight: 624 kg.
Standard: EN 795-A
CEN/TS: 16415-2013
3 Person
SWIFIX 1
H-062-1-12
Standard: EN795/A/B,
CEN/ TS 16415,
EN50308, ANSI Z359, 12007, OSHA 1926,502
Weight: 610 g.
SWIFIX 2
AP-062-2-12
Standard: EN795/A/B,
CEN/ TS 16415,
EN50308, ANSI Z359, 12007, OSHA 1926,502
Weight: 420 g
Since structurally anchored attachment points / devices are on longer
subject to the PPS Directive, they may no longer be CE marked. In
Germany the building inspectorate approval is required for such
products. In Europe, differ-rent national regulations apply to these
products; under certain circumstances a specific approval is required.
MOBILFIX
A-018
Weight: 250 g.
Standard: EN 795/A: 2012
CEN/TS 16415 zertifizier
Person: 3
MOBILFIX is a removable anchor point for regularly
recurring
tasks,
such
as
window
cleaning.
Only the MOBILFIX TERMINAL is permanently installed
at the point of use. The MOBILFIX TERMINAL is virtually
flush with the surface in the wall or the ceiling and is
sealed through the interior spring plug. Thus, dirt cannot
penetrate and visually it is inconspicuous. For tasks the
MOBILFIX is temporarily arrested in the MOBILFIX
TERMINAL. Thanks to the patented shape of the
MOBILFIX, it prevents the carabiner of the fastener from
abrading or fouling the wall.
MOBILFIX
A-018-T
Weight: 200 g.
Standard: EN 795/A: 2012
CEN/TS 16415 zertifizier
Person: 3
SPEED
(1.) Double guide rollers for resistless climbing over rail joints.
(2.) Solid housing of milled aluminium.
(3.) Durable rollers of hardened steel with sleeve bearings.
(4.) Flexibly moving follower roller for automatic adjustment to
various rail thicknesses and a permanent contact pressure.
(5.) Redundant release system with pull-back function and
centrifugal force control independently working from each other.
(6.) Stable snap-fit hook of hardened steel.
(7.) Element of damping, energy absorber. The falling impact
remains under 6 kN even with drop impact tests with a steel weight.
(8.) Self-bolting trilock carabiner.
SKYRAIL
The Skyrail-System is made of seawater resistant aluminium alloy.
The system is certified as a fall protection device according to EN
795/D and may also be used for rope access work.
SKYRAIL
SR-100
SKYRAIL BRACKET T
SR-105
Weight: 1600 g.
Weight: 106 g.
Maximum dimensions for the 2nd holder
Maximum overhang (Cantilever)
Always 2 holders here if no rail is installed after
Rail Connector
Maximum Overhang
Maximum
holder
distance
Rail
Rail Connector
Preferred variant or
variant 2 (layout)
The Legal requirements state that
the user must be trained in the safe
and correct use of the P-FPS and
must practice this regularly, as with
all PPE (Personal Protective
Equipment in general
SKYLOTEC – The right partner
As an ISO 9001 certified training
company Dacon Inspection can
carry out Rope Access training with
the successful students achieving a
IRATA pass certificate which is
known worldwide. Our Training
department can carry this out in a
real working environment at our
location in Bang Chang where we
have an working at height tower
frame, this training is over seen by
fully trained level 3 Instructors. The
course is for 6 days, 5 days training
and 1 day practical exam.

78/4 Moo 6, Sukhumvit Road., Ban Chang, Rayong 21130 Thailand

Transcription

Similar documents

AC Project boroucher(fold in three)Ver.1

First zero carbon store in Thailand (Kom Chad Luek 15/02/2012

Egyptian code cracker

READ MORE - Evelyn Chang

PF Changs Case Study - Hospitality Technology

Demark booklset small size

rrr*f - Garde

moo milk bar - Vicinity Rewards Blog

VIEW THIS PAGE