CBR1000RR 2010-2013 FENDER ELIMINATOR WWW

WWW.RUMBLECONCEPT.COM
FENDER ELIMINATOR
RU39025
CBR1000RR 2010-2013
info@rumbleconcept.com
TEL: (514) 312-2134
FAX: (514) 312-2092
We at Rumble Concept encourage all installations to by performed
by a PROFESSIONAL. If you choose to install this product yourself,
please read all instructions and take all appropriate safety measures
to ensure the proper and safe installation of your new Fender kit.
Before installation: our fender eliminator have been designed for modification purposes, we are not responsible for the use or
misuse of any products, or verification of the local department of motor vehicules.
Included: 1x
1x
2x
5x
3x
4x
4x
2x
1x
1x
2x
Plate holder (Fender eliminator)
Main bracket (Fender eliminator)
Allen button head blk M6x12 QU27948
Lock nut M6 QU27946
Allen flange zinc M6x20
Phillips screws 6.5mm FA36566
Washer Zinc Plated M7 FA35006
Nylon Plate bolt/nut AU27945
Double face tape RU36558
Plate light 3 LED CY25760
signal light CY2788
**After any installations or modifications, the
fender eliminator not returnable. We are not
responsible for any damages to the part
during the installation process, or to the
bike (including the stock undertail part).
1- Remove rear seat
2- Unscrew the 2 Allen bolts at the bottom of the stock mudguard Located on each
side of the reflector.
3- Unscrew the reflector bolt
4- Take off the lower part on the mudguard (plate mount section) along with the
sleeve/spacer by pulling up the stock plate light.
5- Unscrew the 3 bolts holding the stock mudguard (by the storage).
6- Now twist the mud guard and take off the 2 ‘’phillips screws’’ (see pic. A).
7- You can now split the mudguard by pulling on each side (once done you’ll get 3 pcs.)
8- You now have access to the signals and plate light connectors, unplug them.
9- Install LED signals (included) with the 4 small phillip screws also included on your new
Rumble Concept fender eliminator, they have a clear lens but light up orange (amber). With
the double face tape you will place your plate light, all 3 lights included seem to be the
same, but the plate light is white when lit up and is supposed to be marked.
10- Mount the new Rumble plate bracket section on the new Rumble Concept fender
eliminator with the 2 black allen bolts and the 2 lock nuts included.
11- You are now ready to install new Rumble Fender with the 3 Allen zinc Flat head
bolts, washers & lock nut, drive all wiring into the center hole, we recommend to do all
your connections before you install the fender permanently, we suggest to keep stock
connectors from the stock mudguard and to use them on the new signals and plate light,
this will allow an easy un-installation in future and a clean installation with all OEM connectors,
NOTE: with these LED signals you will need a flash controller to slow down flash rate.
12- Test all lights, you can now tighten the Rumble Concept fender eliminator on the bike
using the 3 allen bolts by the inside (trunk), use nuts and washers underneath, do not overtight,
these are lock nut, they wont loosen.
13- Have a safe ride……
A