HONDA RIDGELINE TRUXEDO LO PRO INSTRUCTIONS

Transcription

HONDA RIDGELINE TRUXEDO LO PRO INSTRUCTIONS
Honda ridgeline Truxedo lo pro instructions
Item Part # Description
1. _______ Side Rail, Driver’s Side
2. _______ Side Rail, Passenger’s Side
3. 1116264 Side Rail Top Gap Seal, 2 5/8”
A. 1703769 Cap Screw, M8 x 1.25 x 45 mm
B. 1700433 Lock Washer, 5/16”
C. 1700428 Flat Washer, 5/16”
D. 1703770 Cap Screw, M6 x 1 x 45mm
E. 1700436 Lock Washer, 1/4”
F. 1700427 Flat Washer, 1/4”
1
3
E
F
D
C
TOOLS NEEDED:
T-50 Torx
T-40 Torx
Flat Head Screw Driver
3/8” Ratchet
10 mm Socket /13 mm Socket
3” Extension for 3/8 Ratchet
9/16” Socket
B
A
2
step 1: Using a T-50 torx wrench, remove top tie down hooks at cab
end of both driver’s and passenger’s sides of pickup bed.
Immediately replace existing screws in front holes only.
step 3: Fasten passenger’s side rail to inside of pickup bed with M6 screws
, lock washers , and flat washers , in locations shown.
fasten in these
locations
tie down hook
NOTE: Top tie down hooks
will not be replaced.
step 2: Using a T-40 trox wrench, remove factory installed M6
fasteners.
install m6 cap screw &
step 4: Insert top gap seal (item 3) as shown. Keep seal above
both existing tie down bracket holes.
washers here
By TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877-878-9336 • Fax: (605) 664-9304 www.truxedo.com
P/N 1116708 Rev. D
Honda ridgeline Truxedo lo pro instructions
step 5: Install M8 screw , lock washer , and flat washer
location shown.
in
STEP 9: Open and close cover, and adjust cover tension as shown in
owner’s manual. Use supplied loop to lift and adjust cover.
install m8 cap screw
& washers here
step 6: Tighten fasteners. Repeat steps 1 - 4 on driver’s side.
step 7: Install cover assembly and header guides as shown in
owner’s manual.
step 8: Seal corners: Roll cover partially opened. Form the
factory installed header seal on the cab end of the cover
around the corners of the pickup bed. Trim ends of seal
if needed to achieve desired fit.
STEP 10:
If gap in front, loosen side rails and
move side rails forward.
By TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877-878-9336 • Fax: (605) 664-9304 www.truxedo.com
P/N 1116708 Rev. D

Similar documents