2592 General Directions e

English
1/4
The Pattern
7
6
4
8
ADJUST IF NEEDED
Make adjustments before placing
pattern on fabric.
TO LENGTHEN:
Cut pattern
between
lengthen or
shorten lines.
Spread pattern
evenly, the
amount needed
and tape to
paper.
PLACE SOLID LINE on
fold of fabric.
CENTER FRONT OR
BACK of garment.
5
NOTCHES
9
11
13
DOTS
CUTTING LINE
12
LENGTHEN OR
SHORTEN LINES
C
SEAM ALLOWANCE: 5/8" (1.5cm)
unless otherwise stated is included but
not printed on MULTI-SIZE PATTERNS.
Mark your size with colored felt tip pen.
See chart on tissue for how to use MULTISIZE PATTERNS.
14
1-UPPER FRONT -A,B
2-POCKET -A
3-UPPER BACK -A,B
4-LOWER FRONT -A,B
5-LOWER BACK -A,B
6-BIB -A
7-WAISTBAND
8-TIE END -A,B
9-SHOULDER STRAP -A,C
10-UPPER FRONT AND BACK -C,D
11-MIDDLE FRONT AND BACK -C,D
12-LOWER FRONT AND BACK -C,D
13-BIB -C
14-TIE END -C,D
D
A
D
C
B
pattern printed
side down
★
✻
pattern printed
side up
See
SPECIAL
CUTTING
NOTES
When lengthen or shorten lines are
not given, make adjustments at
lower edge of pattern.
Sewing
SEW garment following Sewing Directions.
PIN or machine-baste seams matching notches.
STITCH 5/8" (1.5 cm) seams unless otherwise stated.
PRESS seams open unless otherwise indicated clipping when necessary so
seams will lie flat.
• TRIM seams to reduce bulk, as shown below.
•
•
•
•
Trim enclosed
seams into layers
Cutting
Layouts
TO SHORTEN:
At lengthen or
shorten lines,
make an even
pleat taking up
amount needed.
Tape in place.
Trim corners
Clip inner
curves
Notch outer
curves
BEFORE CUTTING:
PRESS pattern pieces with a warm dry
iron. PRE-SHRINK fabric by pre-washing
washables or steam-pressing nonwashables.
AFTER CUTTING:
Transfer markings to WRONG side
of fabric before removing pattern.
Use pin and chalk method or
dressmaker’s tracing paper and
wheel.
CIRCLE your cutting layout.
To Quick Mark:
PIN pattern to fabric as shown in Cutting
Layouts.
• Snip edge of fabric to mark
notches, ends of fold lines and
center lines.
• FOR DOUBLE THICKNESS: Fold
fabric with RIGHT sides together.
• Pin mark dots.
• FOR SINGLE THICKNESS: Place
fabric RIGHT side up.
• FOR PILE, SHADED OR ONE WAY
DESIGN FABRICS: Use “with nap”
layouts
SPECIAL CUTTING NOTES
★
Mark small
✻
arrows along both
If layout
shows a piece
extending past
fold, cut out all
pieces except
piece that
extends.
selvages indicating
direction of nap or
design. Fold fabric
crosswise with
RIGHT sides
together, and cut
along fold (a).
Open out
fabric to single
thickness. Cut
extending
piece on
RIGHT side of
fabric in
position
shown.
Turn one fabric
layer around so
arrows on both
layers go in the
same direction.
Place RIGHT sides
together (b).
a.
SELVAGE
SELVAGE
2
Cutting/Marking
CROSSWISE FOLD
SYMBOLS
GRAIN LINE Place on
straight grain of fabric
parallel to selvage
3
1
B
info@simplicity.com
General Directions
14 pieces given
10
E-mail
e
http://www.simplicity.com
1-888-588-2700
Thank you for purchasing this Simplicity pattern.
We have made every effort to provide you with a high quality product.
A
Web Site
U.S. & Canada Toll-Free
✁
2592
®
SELVAGES
SELVAGE
b.
SELVAGES
B APRON
SELVAGE
USE PIECES 1 3 7 8
SELVAGE
POSITION OF PATTERN PIECES MAY VARY SLIGHTLY ACCORDING
TO YOUR PATTERN SIZE
7
7
SEL.
44" 45" (115CM)
WITH NAP
ALL SIZES
44" 45" (115CM)
WITH NAP
SIZE L
1
8
3
SELVAGES
USE PIECES 4 5
CROSSWISE FOLD
USE PIECES 1 2 3 4 5 6 7 8 9
CUT ONE OF PIECE 2
44" 45" (115CM)
WITH NAP
ALL SIZES
SELVAGES
11
10
9
13
FOLD
CONTRAST
14
12
SEL.
FOLD
A APRONLENGTHWISE STRIPED FABRIC
SELVAGES
FOLD
D APRON
USE PIECES 7 10 11 12
CUT ONE OF PIECE 7
SELVAGES
44" 45" (115CM)
WITH NAP
ALL SIZES
4
7
12
11
10
5
FOLD
SELVAGES
2
44" 45" (115CM)
WITH NAP
ALL SIZES
C APRON
SELVAGE
7
8
SEL.
3
9
FOLD
CROSSWISE FOLD
6
CONTRAST TIE ENDS
USE PIECES 7 9 10 11 12 13 14
CUT ONE OF PIECE 7
5
4
SELVAGES
© Copyright 2009—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.
44" 45" (115CM)
WITH NAP
SIZES S M
USE PIECE 14
7
9
12
14
11
SELVAGES
SELVAGES
10
13
FOLD
44" 45" (115CM)
WITH NAP
ALL SIZES
14
FOLD
English
2592
Sewing Directions
2/4
FABRIC
KEY
RIGHT SIDE
WRONG SIDE
INTERFACING
CONTINUE AS FOLLOW FOR BOTH VIEWS
LINING
6. Stitch lower front to lower back at side seams.
Stitch along seam line and stitching lines on upper edge of
lower front and back, stitching through small dots at inner
corners. Clip to stitching at small dots, being careful not to
clip through stitching. Press under upper edge along
stitching.
6
Read General Directions on page 1 before you begin.
APRON A, B
1
1. Stitch upper front to upper back at side seams.
7
7. FOR VIEW B- On OUTSIDE, pin single fold bias tape to
lower front and back, placing upper edge of tape 1/2” (1.3cm)
from finished edge, folding out fullness at corners.
Stitch close to both long edges of tape.
POCKET AND TRIM A
2
2. On OUTSIDE, pin pregathered eyelet to RIGHT upper front,
placing bound edge just over pocket line, folding out fullness
at points, turning under ends at upper edge, as shown. Stitch
along bound edge of trim.
Pin pregathered trim to lower edge of upper front and back,
placing bound edge just over seam line, folding out fullness at
corners. Stitch along bound edge of trim.
CONTINUE AS FOLLOW FOR BOTH VIEWS
8
8. On OUTSIDE, pin lower apron to upper apron, matching
centers front and side seams, placing pressed edge along
seam line and having raw edges even on INSIDE, as shown.
Stitch apron close to pressed edge.
3. To EDGE FINISH upper raw edge of pocket...stitch under 1/4"
(6mm), zig-zag, OR overlock/serge.
Turn upper edge to OUTSIDE along fold line, forming facing.
Stitch along seam line on raw edges; trim to 1/4" (6mm).
3
9. Press under hem allowance on back edges of apron.
To form narrow hem, tuck under raw edge to meet crease.
Press.
Stitch hem in place.
Press up hem at lower edge.
To EDGE FINISH the raw edge...stitch under 1/4" (6mm), zigzag, OR overlock/serge.
Slip-stitch or machine-stitch hem in place.
To gather upper edge of apron, stitch along seam line and
1/4" (6mm) INSIDE seam line, using a long machine-stitch.
9
4
4. Turn facing to INSIDE, turning under raw edges along
stitching; press.
Slip-stitch or machine-stitch facing close to inner edge.
5
10
5. On OUTSIDE, pin pocket to RIGHT upper front along pocket
line over bound edge of trim.
Stitch close to side and lower edges.
© Copyright 2009—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.
BIB A
10. With RIGHT sides together, stitch bib facing to bib, stitching
along stitching lines and seam lines, leaving lower edge open
to turn. Trim seam and corners; clip to stitching at center
front.
English
2592
3/4
16
11
11. Turn bib; press. Machine-baste raw edges together.
On OUTSIDE, lap finished edges of bib over bound edge of
pregathered eyelet, folding out fullness at corners. Stitch
close to finished edges of bib, catching in bound edge of trim.
16. Pin WRONG side of tie end to RIGHT side of waistband,
matching small and large dots, as shown. Baste.
17
12
17. Fold waistband in half, lengthwise, with RIGHT sides
together, matching small dots. Stitch ends. Trim seams.
12. With RIGHT sides together, pin bib to waistband, matching
centers front. Baste.
CONTINUE AS FOLLOW FOR BOTH VIEWS
13
18
13. Press under 5/8” (1.5cm) on unnotched edge of waistband;
trim to 1/4” (6mm).
Pin WRONG side of apron to RIGHT side of waistband,
matching centers front and small dots, placing side seams at
inner small dots. Pull up gathering stitches to fit. Baste.
Stitch. Trim seam. Press band and bib A out, pressing seam
toward band.
18. Turn band to OUTSIDE; press, pressing tie ends out. Pin
pressed edge of band over seam. Stitch band close to
pressed edge.
19
SHOULDER STRAPS A
14
19. Fold shoulder strap in half, lengthwise, with RIGHT sides
together. Stitch long edge, leaving ends open.
14. Press under hem allowance on long edges and end of tie end
without small and large dots.
To form narrow hem, tuck under raw edge to meet crease.
Press.
Stitch hem in place.
20
15
15. To make pleat in remaining end, on OUTSIDE, fold along
solid line.
Bring fold to broken line; pin.
Baste across raw edge.
© Copyright 2009—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.
20. Turn strap RIGHT side out; press. If you prefer, zig-zag or
overlock/serge front end of strap.
On INSIDE, pin front end of strap to bib facing, matching
small and large dots. On OUTSIDE, stitch close to finished
edge of bib across end of strap.
Cross straps in back. On INSIDE pin back end of strap to
waistband, matching small and large dots. Try on apron.
Adjust straps to fit. On OUTSIDE, stitch waistband close to
pressed edge across end of strap. If you prefer, trim end of
straps to within 5/8” (1.5cm) of stitching. Zig-zag or
overlock/serge back end of strap.
English
2592
4/4
APRON C, D
CONTINUE AS FOLLOWS FOR BOTH VIEWS
5
1
1. Encase unnotched edge of each apron section in double fold
bias tape.
5. Press under 5/8” (1.5cm) on unnotched edge of waistband;
trim to 1/4” (6mm).
Clip notched edge of apron to stitching along curves.
Pin WRONG side of apron to RIGHT side of band, matching
centers front and placing back edges at small dots. Stitch.
Trim seam. Press band and bib C out, pressing seam toward
band.
The tape comes prefolded, with one side slightly wider than
the other.
The wider side is to be used on the WRONG side of the
apron so that when the tape is stitched in place from the
RIGHT side, both edges are sure to be caught in the
stitching.
6
6. Press under hem allowance on long edges and end of tie end
without small and large dots.
Open out pointed corner. Turn under corner diagonally where
crease lines cross; trim to 1/4" (6mm).
To form narrow hem, tuck under raw edge to meet crease.
Press.
Stitch hem in place.
To gather remaining end of tie end, stitch along seam line and
1/4" (6mm) INSIDE seam line, using a long machine-stitch.
DOUBLE FOLD BIAS TAPE
TIP- when applying tape to a outward curve, preshape it with
a steam iron, stretching the fold edge and press.
OUTWARD CURVE
7
2
7. Pin WRONG side of tie end to RIGHT side of waistband,
matching small and large dots, as shown. Pull up gathering
stitches to fit. Baste.
2. Pin WRONG side of middle front and back to RIGHT side of
lower front and back, matching centers front.
Pin WRONG side of upper front and back to RIGHT side of
middle front and back, matching centers front. Machine-stitch
notched edges together through all thicknesses.
8
8. Fold waistband in half, lengthwise, with RIGHT sides
together, matching small dots. Stitch ends. Trim seams.
3
BIB C
3. Encase side and upper edges of bib in double fold bias tape.
9
9. Turn band to OUTSIDE; press, pressing tie ends out. Pin
pressed edge of band over seam. Stitch band close to
pressed edge.
4
4. With RIGHT sides together, pin bib to waistband, matching
centers front. Baste.
SHOULDER STRAPS C
Prepare and apply shoulder straps to apron same as
Apron A, see steps 19 and 20.
© Copyright 2009—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.