How to make the d8b PSU/CPU fanless

How to make the d8b PSU/CPU fanless
Do this only if you know what you are doing and if you want to use your d8b as a pure DAW
controller !
Warning: you will loose the Audio functionality of the d8b
Warning: check if you have the 230V or the 110V CPU/PSU. You need the right 12V fanless
switching power supply for that.
Order SNT MW60-12 :: Schaltnetzteil, geschlossen, 12V / 5,0A / 60W
www.reichelt.de
http://www.reichelt.de/Schaltnetzteile-Case-geschlossen/SNT-MW6012/3/index.html?&ACTION=3&LA=2&ARTICLE=57482&GROUPID=4959&artnr=SNT+MW60-12
or similar (check if you need a 110 (US) or 230V EU version)
1. Disconnect the 230V/110V site of the Compute Power supply
2. Disassemble the computer power supply and disconnect ALL connectors. This will make the
CPU dead. Remove computer power supply.
IMPORTANT ! Also disconnect the plug “A” in the picture downwards. Cut this connecter
from the power supply in a way that you have the most possible cable length! You will need
this cable for the new power supply. Also disconnect the connector “B” (brown and blue
cable).
B
A
3. Mount the new fanless 12V power supply to the location of the old computer power supply.
4. Connect the primary 230/110V connectors to the connector “B”. blue is N, brown is phase L
(110V/230V). Change the fuse F1 to a fitting value for your new power supply !!! if the
supply has a fuse build in you can short the fuse F1.
B
5. Connect the cable that you have cutted from the computer power supply to your new fanless
12V supply. Yellow should be V+ (12V) the black cables should be GND.
6. Plug the cable back to the connector “A”
A
A
A