How to make VagCom 409 cable to work like INPA/DIS...

How to make VagCom 409 cable to work like INPA/DIS interface
1. This is the picture of VagCom 409 open interface , it very cheap from China’s sellers ,
FTDI chip inside is FT232BL
2. If you have that chip FT232BL FTDI , you must bridge pin 7 and 8 ( if your device
don’t have pin on place to pin 8 you must get one free pin and replace the places)
a. You must get one simple NPN transistor and connect Base NPN to OBDII pin 1
cable via 10k- 0.25W resistor
b.
Black cable from USB you must connect to Emitter NPN or OBDII pin 4
c.
Red cable from USB you must connect to Collector NPN via 4k7- 0.25W
resistor
d.
From 20 pin on FTDI chip you must solder cable to Collector NPN and bridge
pin’s 17 and 18 on chip
These few steps make your VagCom 409 interface work with INPA/DIS
software
That you can make if you have FTDI 232 BL chip inside your
VAGCom , BUT if you have FTDI 232 RL chip inside you must
follow the next few steps
See next page………………………………………..
If you have FTDI 232 RL chip inside your device which look like
this:
You have two options:
1. Cable only for diagnostic –not possible to program with INPA/ DIS software
Hardware :
You must bridge pin 7 and 8 on OBDII ( if your device don’t have pin on place
to pin 8 you must get one free pin and replace the places)
Software:
You must get Mprog program – from here
it’s free downloaded – then you must replace RI# and DSR# signals with MProg
( it’s easy to work with it)
Note:
The disadvantages are that the cable detects that the car is constantly in
contact (even if it is not), this flaw makes it unfit for coding, because the
confirmation of the function you want to encrypt a DIS should be excluded
and included contact
2. Fully functional cable
To have a fully functional cable (coding and diagnostic DIS), it must be overhauled in
order to detect whether the car is of contact.
Hardware:
a.
You must get one simple NPN transistor and connect Base NPN to
OBDII pin 1 cable via 10k- 0.25W resistor
Black cable from USB you must connect to Emitter NPN or OBDII
pin 4
c. Red cable from USB you must connect to Collector NPN via 4k70.25W resistor
d. From 9 pin on FTDI chip you must solder cable to Collector NPN
b.
Software:
a. Using MProg you must invert only RI# signal
This document was written specifically for
ecuconnection forum
Good luck to all, and if you need some other support like programs or
info you may contact me on PM .