How to configure BMW ICOM A+B+C BMW ISID on VMware... BMW ICOM A+B+C BMW ISID Configuration manual on VMware workstation

How to configure BMW ICOM A+B+C BMW ISID on VMware workstation
BMW ICOM A+B+C BMW ISID Configuration manual on VMware workstation
order the top quality BMW ICOM A+B+C from obd2motor.com
1: install VMware workstation 8, run and select virtual network editor
2 Configure network exactlly as on picture, at green ellipse marked place for vmnet().
select network adapter which will be used for connection with icom,ops or enet cable.
3：3. Open BMW icom BMW A+B+C ISID virtual machine,if you have window xp(32bit,or 52bit) or
7, and RAM, more than 3-5G, then you can set BMW ICOM ISID memory size from 1536MB to
2048MB, BMW ICOM ISSS can process exx with 2048MB instead of 4096MB, but will show you
warnings, don't use others vaules since this will casue some failures or error.
4: open VM properties and check network adapter set to VMnet2,close and boot
5. when show this menu. just select "i moved it"
6. then. wait for until VM start, and BMW ICOM ISTA icom gets active
7. Connect BMW icom using network cable to pc, then connect BMW icom to car,
wait for it
8. click right mouse button over connection icon on the right botton VM window cornet and
select " settings..."
9.
Change network connection type to "Bridged" then press "ok"
10. connection icon will change to inactive state and after some time. gets back to active, wait
1-2 mint. then start BMW ISTA via one-double left mouse button click over BMW ista-d icon in
WSM interface
11. for BMW icom ISID select 'identification'
12. next for BMW icom ISID click on "Read out vehicle data" then "OK"
13. then, wait for some times. In BMW isid "Connection manager" list should appear your icom,
select it and press "set up connection" or "connect"