T-Foil Vapor Barrier & Insulation Hanging System

T-Foil
Vapor Barrier & Insulation Hanging System
Standard T-Foil Specification:
Insulation Holder / Hanging System
Polypropylene/Scrim/Kraft - White
Foil/Scrim/Kraft - Foil
69# liner board
Polypropylene
Side Exposed:
What is T-Foil?
T-Foil is an all-in-one vapor barrier and insulation hanging system.
This all-in-one system is installer friendly, does not compress
Flame Spread 10
Smoke Developed 35
ASTM E-84/Ul 723
Foil (polyester)
Side Exposed:
Flame Spread 10
Smoke Developed 40
ASTM E-84/Ul 723
Permeance-ASTE E 96
.02perm perforated
ASTM E96 Procedure A
insulation, allows for ventilation, packaged for easy transport and can
Details
be manufactured to suit your specific job requirements.
•
•
•
•
•
•
•
•
Varying drop card sizes: 4” to 18”
Allows for proper ventilation and air flow
Vapor Barrier UL tested
T-Foil is packed 5/30’ pieces per roll equaling 300 sq ft.
This hanging system does not compress insulation
Great for wooden structures
T-Foil is available in White, Black or Foil Facing
Manufactured in Vancouver, WA
T-Foil installed:
2’ on center with 12” drop card
Example of T-Foil installation
before and after
Manufactured by:
Your Source for High Quality T-Foil
www.T-Foil.com • 360.635.1963
2600 NE Andresen Road, Suite 100 · Vancouver, WA 98661 · Email: scott@t-foil.com · Fax: 360.693.7811
T-Foil
Vapor Barrier & Insulation Hanging System
Standard T-foil
Staple with 508-C
minimum when stapling
drop card to trusses
Mass insulation
installed
Use Ace 70001
staples only to staple
bottom every 4 inches
No other acceptable
T-Foil lnstallation Requirements
• Always verify square foot requirements before ordering and order in 300 sf increments
• T-Foil can be ordered to handle up to R49 insulation material
• W
hen stapling drop card to trusses, make sure to use a 508-C quality staple and
staple every 5 inches
• When stapling bottom overlapping section, make sure to use ACE 70001 staples only
• W
hen stapling bottom overlapping section, make sure vapor barrier is overlapped
1 inch and stapled every 4 inches
• Make sure to account for correct air space/ventilation requirements
• Make sure moisture content is not excessive when installing T-Foil
Any questions regarding T-Foil installation please call JAS Enterprises at:
(360)
635-1963
www.T-Foil.com • 360.635.1963
2600 NE Andresen Road, Suite 100 · Vancouver, WA 98661 · Email: scott@t-foil.com · Fax: 360.693.7811