Installation Guide EoC Rackmount Tray Model NV-RMEC16 for 60 Watt Power Supplies

Installation Guide
EoC Rackmount Tray
for 60 Watt Power Supplies
Model NV-RMEC16
12.
NV-DPSC4
4.
2.
REAR
VIEW
5.
170
1
NV
-PS
56-
60W
9.
NV
-EC
NV-4BNC
11.
NV
-EC
170
1
56NV
-PS
NV
-EC
170
1
56NV
-PS
60W
60W
1
170
NV
-EC
NV
-PS
56-
60W
6.
NV-RM
EC16
3.
7.
8.
Instructions:
1.
Verify Power supplies are off and AC inlet power cords are unplugged before starting.
2.
For the first transceiver set, attach male BNC from the NV-4BNC adaptor to the female BNC (”Coax”) of the
NV-EC1701 transceiver. Rotate the NV-4BNC so the NVT logo is facing up , as shown.
3.
Insert and allign this assembly into the NV-RMEC16 chasis.
4.
Use SEMS screws to secure NV-4BNC adaptor to rear tray panel. Torque to 8 in-lbs (0.8 Nm).
5.
Use Kepnuts and washer to secure the NV-EC1701 to the tray stud. Torque to 8 in-lbs (0.8 Nm).
6.
Place NV-PS56-60W power supply in tray, with coiled output cords between the power supply and its
NV-EC1701 transceiver.
7.
Plug barrel connector into NV-EC1701 56VDC power inlet.
8.
Secure power supply barrel plug cord to chassis with cable-tie.
9.
Connect NV-DPSC4 IEC 380 plug through large cutouts in chassis into NV-PS56-60W power inlet.
10. Repeat steps 2 through 9 for remaining transceiver/power supply asemblies.
11. Install into 19” rack frame using four large phillips panhead (10-24 x 3/4”) screws.
12. Connect male end of NV-DPSC4 onto an IEC power cord and plug into 115/230V 50/60 Hz power source.
Network Video Technologies
Page 1 of 1
(+1) 650.462.8100 • +44 (0) 208 977-6614
nvt.com • info@nvt.com
Copyright © 2014 NVT, Inc.
2014/02 451-1426-1-B