TH15 TERRACE HEATER

TH15 TERRACE HEATER
08/19623/0
(UK)
Issue 0
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility
(EMC) EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336
1
Handle
Output control switch
(on the back)
Safety bracket
Heating bars
Heating element
Safety bracket
Mains cable & plug
Safety switch
(on the underside of stand)
Stand
4
2
Pin
3
Dimplex TH15 Terrace Heater
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
Never immerse the appliance, the connecting cable or
plug in water.
The electric heater must not be used in the immediate
vicinity of a bath, shower or swimming pool.
Use the appliance only in a dry environment. If you are
using it on a balcony or on the terrace, make absolutely
sure that the appliance is under cover and protected
against damp.
Only connect the appliance to a properly installed socket
outlet with the specified voltage as that on the rating
label. Shaver sockets that are not earthed are not
suitable.
The appliance must be switched off when you plug it
into the power socket.
Do not use the heater if the appliance or power cord are
visibly damaged or if the heater has been dropped.
Check the heating bars and connection cable regularly.
Prevent damage to the cable from sharp edges or heat.
Place the cable in such a way that it cannot become a
stumbling trap.
Connect the appliance only to a 1,500 watt output
extension lead.
Remove the mains plug, if a disturbance occurs during
use, after use and before cleaning. When doing so,
always pull the plug itself - never the cable.
The supply cord should be regularly examined for signs
of damage and the appliance is not to be used if the
cord is damaged.
If the mains lead is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Do not locate the heater immediately above or below a
fixed socket outlet or connection box.
Keep combustible materials away from the heater.
Do not position patio furniture, sunshades, awnings and
other combustible materials too close to the heater.
Never cover the appliance and never place anything over
or on the appliance. Keep it away from all flammable
objects - at a safe distance of at least 500mm.
Never operate the appliance without supervision.
Stand the electric heater on a level surface. The electric
heater will only work if placed on a level surface. On an
uneven ground the safety switch on the underside of
the appliance may not be pressed in and the electric
heater will fail to operate. For safety reasons this switch
must not be bridged or otherwise disabled. Please keep
the safety switch clean to ensure that it functions
correctly.
Never use the appliance together with switch units such
as a timer which automatically turns the appliance on –
it may become a fire hazard, if the appliance has been
accidentally covered or moved!
Never clean the appliance with highly flammable cleaning
agents such as petrol or spirit.
Let the appliance cool completely before storing it away.
General
Your Dimplex Terrace Heater is intended for use on a patio or
terrace area adjoining your home. It is specifically designed
for domestic use, and is not suitable for commercial
applications.
Electrical
This heater must only be connected to an A.C.~ supply. The
supply voltage must correspond to the voltage shown on the
heaters rating label. This heater is fitted with a plug
incorporating a 13 amp fuse. When replacing the fuse, a 13
amp fuse approved by ASTA to BS 1362 must be used.
IMPORTANT : The wires in this mains lead are coloured in
accordance with the following code :
BROWN :
LIVE
BLUE :
NEUTRAL
GREEN & YELLOW :
EARTH
As the colours of the wires in the mains lead may not
correspond with the coloured markings in your plug, proceed
as follows :
Connect the BROWN wire to the terminal marked ‘L’ or
coloured RED. Connect the BLUE wire to the terminal marked
‘N’ or coloured BLACK. Note : ‘L’ or ‘N’ must not be connected
to the EARTH terminal marked ‘E’ or
or coloured GREEN
or GREEN AND YELLOW.
If in doubt, consult your electrician.
Assembling the appliance
Only after the heater has been fully assembled, should the
protective polystyrene foam be removed from the heating
element.
Place the heating element together with the stand carefully
on the floor so that the heating bars face downwards.
Place the lower end of the stand into the base half which has
a pin on the inside. The pin should be pushed into the top
hole of the stand.
Place the second half of the base on to the first half and
press the two halves together until they engage.
Insert the screw provided in the hole on the side of the base
in which there is not a nut, and screw everything together
tight for use - see Fig. 2.
If a 13 A (BS1363) plug is used it must be fitted with a 13 A
fuse conforming to BS1362 and be ASTA approved. If any
other type of plug is used, the appliance must be protected
by a 10A fuse either in the plug or adapter or at the distribution
board.
If in doubt – consult a qualified electrician.
Never use the plug without closing the fuse cover.
Heating
1. Stand the electric heater in a dry place. The floor must be
even so that the safety switch on the underside is pressed
in.
2.Turn the heating element until it engages horizontally.
Hazard: Only connect the heater to a properly installed
mains socket outlet with the specified voltage as that on
the rating label.
3. Ensure the output control switch is set to 0 and connect
the plug to a socket.
4. Adjust with the output control switch to the desired setting:
0 = Off
1 = one heating bar On
2 = both heating bars On
After use
Cleaning
Fire hazards: Let the appliance cool completely before storing
it away.
WARNING: BEFORE UNDERTAKING CLEANING OR
MAINTENANCE WORK ON THE APPLIANCE, DISCONNECT
THE ELECTRICITY SUPPLY.
Before cleaning, unplug the appliance and allow the
appliance to cool before cleaning.
1. Once the desired room temperature has been reached,
switch the appliance off with the output control switch.
2. When you do not want to use the appliance any longer,
remove the plug and allow to cool.
Wipe the appliance with a slightly dampened cloth.
3. To store the appliance in a space-saving way, turn the
heating element back into the vertical position - see Fig. 4.
The heating bars are best cleaned with a paint brush with
long soft bristles.
Safety Warnings
After Sales Service
Never touch the front of the heating element, the metal casing
or the two brackets at the front during or after use. These
parts become very hot.
Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (excluding element & subject to
availability) provided it has been installed and operated in
accordance with these instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales service you should contact
our customer services help desk on 0870 727 0101. It would
assist us if you can quote the model number, series, date of
purchase, and nature of the fault at the time of your call. The
customer services help desk will also be able to advise you
should you need to purchase any spares.
Please do not return a faulty product to us in the first instance
as this may result in loss or damage and delay in providing
you with a satisfactory service.
Please retain your receipt as proof of purchase.
While the appliance is connected to the power supply, move
it only by the handle at the back of the heating element. Change
the position of the appliance only when it is switched off and
cool.
Do not get hair or clothing too near the appliance while it is
switched on.
Operate the appliance only in a fully assembled state,
standing upright and with the heating element set horizontally.
The temperature of the casing might otherwise increase too
much and lead to burning.
Do not use the appliance near combustible materials, gases
and liquids.
Glen Dimplex UK Limited
Millbrook House
Grange Drive
Hedge End
Southampton
Hampshire. SO30 2DF
UK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00PM Sat)
Customer Services:
Republic of Ireland
Tel.
Fax.
e-mail
Tel.
0870 7270101
0870 7270102
customer.services@glendimplex.com
01 8424833
[c] Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.