HiTEC® 475 Automatic Transmission Fluid Package

DRIVELINE
HiTEC® 475
Automatic Transmission Fluid Package
Designed to Meet Ford’s M2C33-F (Type F) and M2C33-G (Type
G) ATF Specification Requirements
DRIVELINE
HiTEC® 475 Automatic Transmission Fluid Package
Designed to Meet Ford’s M2C33-F (Type F) and M2C33-G (Type G) ATF Specification Requirements
Recommended Dosage
The recommended treat-rate for HiTEC® 475 additive is 7.65% wt. in good
quality base stocks for Ford Type F and Ford Type G Automatic Transmission
Fluid applications. Please contact your Afton Chemical representative for
specific recommendations.
Typical characteristics
Appearance:
Yellow viscous liquid
Density at 15.6 °C, g/ml:
0.902
2
Kinematic Viscosity at 100°C, mm /s:198
Flash Point (PMC), °C:
125 min
Friction Graph Depicting the Difference between DEXRON®
and Ford Type F & G
The coefficient of friction at point (A) on the Ford fluid is up to 50% higher than for a DEXRON® III
at point (B).
(B)
Engagement Time
Low static friction, typical of
DEXRON® type fluid
NOTE: The friction curves are not drawn to scale
Handling Information
Max Handling Temp: 60°C
Shelf Life: 24 months at ambient
For
d
M2
C33
-F a
Volv
nd
o9
-G
733
0
Approvals
Product
HiTEC® 475
ATF Specifications
3
Product Status
Meets Requirement
(A)
Friction Torque
HiTEC® 475 additive package is specifically developed to meet the Ford
M2C33-F (Type F) and M2C-33-G (Type G) Automatic Transmission Fluid
Specifications.
Fluids meeting these ATF specifications are not friction modified and
are classified as “high static friction” fluids. They are required in Ford
automatic transmissions built between 1976 and 1981, where Type F and
Type G fluids are specified.
ATFs based on HiTEC® 475 can also be used in power steering and
automatic transmission systems where Volvo 97330 is specified.
Friction Torque
Key Performance Benefits
3
Specification Status
3 Obsolete
© 2015. Afton Chemical Corporation is a wholly-owned subsidiary of NewMarket Corporation (NYSE:NEU). HiTEC® is a trademark of Afton Chemical Corporation. 01/15.
The information in this bulletin is, to our best knowledge, sure and accurate, but all recommendations or suggestions are made without guarantee since the conditions of use
are beyond our control. Afton Chemical Corporation and its affiliates disclaim any liability incurred in connection with the use of these data or suggestions. Furthermore, nothing
contained herein shall be construed as a recommendation to use any product in conflict with existing patents covering any material or its use.
Engagement Time
High static friction typical of Ford
M2C 33-F&G fluid