here - THERMOCOAX ISOPAD GmbH

Thermocoax Isopad Heating Solutions for Drums
Flexible Drum Heating Jacket Series IDR-G
Flexible Isopad Heating Jackets of Series IDR-G are easy to install
around drums to warm up their content. They are insulated to
provide the most efficient heat transfer. Therefore the heat is
distributed towards the medium inside with less energy loss than
most simple heating bands. In addition an optional flexible insulated
cover from Isopad may be used for the top of the drum.
Rapid and direct heat-up times are generated through constant
power output and digital control. Through the pre-installed
controller unit on the jacket and the single power supply lead the
heating jackets are a practical, flexible and space saving solution.
The drum heating jackets are providing upmost efficiency at various
application methods from frost protection to desired regulation of
the viscosity of the medium.
Drum heating jackets are designed for use in ordinary areas (nonhazardous). The outer sheath is made of glass-fiber reinforced
silicone which remains flexible yet sturdy. By using the right
manufacturing method the design provides protection in wet areas
of use (Ingress Protection up to IP65).
The heating jackets are installed using the Velcro tape which is
mounted over the complete closure line. This method provides fast
and easy installation with an optimum of fixation around the drum.
The materials used for the flexible drum heating jackets are suitable
for operating temperatures up to 180°C. This operating range may
be used for metal drums with suitable surface finish or paint. For
drums made of plastic or composite we recommend a maximum
operating temperature of 70°C depending on the material. For
applications with lower performance ratings the power output may be reduced to save energy consumption.
The built-on controller unit junction box of the drum heating jackets is designed to provide direct adjustments of
the control temperature as well as locking against use or change of settings. The housing is made of rigid plastic
which provides protection against splashing water. After selection
of the control temperature and other parameters the heating
jacket can be operated using the ON and OFF main switch.
The heating jackets for drum are design mainly for use in industrial
areas and shall therefore only be installed and operated by well
trained staff and personnel.
1|Page
DOC IDR-G BROCHURE 2015R0 EN
Overview Product Features:











Fully insulated heating for best efficiency
Easy to use digital controller unit
Constant power output for rapid heat up times
For use on metal and plastic drums
Grounded heating element fulfills requirements to guideline 2006/95/EG
Regulation of viscosity
Frost protection
Maintaing temperature
Melting of solids
Warming up of Media
Thermal Mixing
Overview Technical Data:









Standard Sizes to fit drums of 200L volumes
Glass-fiber reinforced silicone outer sheath
25 mm thermal insulation
Digital Controller with acoustic/optical alarm
Dielectric strength >2000 Volts
Flexible Power Supply Lead 1.8 m
Ingress Protection Level IP65
Electrical Protection Class I
Optional insulated cover for top
Please contact us for your individual design requirements to find your best possible application solution!
Thermocoax Isopad GmbH
Englerstrasse 11
D-69126 HEIDELBERG
GERMANY
Phone : +49 6221 3043-0
Fax : +49 6221 3043-956
E-Mail: info@isopad-solutions.com
Web: www.isopad-solutions.com
Thermocoax SAS
40bd Henri Sellier
F-92156 SURESNES CEDEX
FRANCE
Phone : +33 141 38 80 50
Fax : +33 141 38 80 70
E-Mail: info@thermocoax.com
Web: www.thermocoax.com
2|Page
DOC IDR-G BROCHURE 2015R0 EN