Button Sewing Foot

Baby Lock
Sewing Accessories
Adjustable Guide foot (BLQ2-AGF)
Adjustable Guide foot (BLQ2-AGF)
Button Sewing Foot
(BLQ2-BS)
Instructions
Attach 2 or 4-hole buttons to garments and other
projects with your machine. This convenient foot holds
buttons in place, allowing your machine to attach
buttons to fabric with a sturdy zigzag stitch. This foot is
perfect for buttons that can lay flat without much
Needsthread
new photo can not see the guide
shank.
marks
place the grey guide farther to the right
1. Remove the presser foot.
For projects that require the utmost accuracy, suchNeeds
as garment
sewing,
topstitching
new photo
can
not see theorguide
piecing
the
perfect
quilt, this
footto
comes
prepared to help. 2.
TheAttach
built-inthe
ruler
withSewing Foot.
Button
marks
place
thewhile
grey guide
farther
the right
INSTRUCTIONS:
adjustable guide is perfect for keeping your measurements precise at all times.
Removing
therequire
presser
For projects that
the foot
utmost accuracy, such as garment sewing, topstitching or
3. Select stitch #43 from group 2-B
Raise
thethe
presser
foot
(a).quilt, this foot comes prepared to help. The built-in ruler with
Removing
the
presser
foot
piecing
perfect
while
Raise
the presser
foot
(a).
adjustable
guide
is perfect
for keeping your measurements precise at all times.
4. Place the fabric under the foot.
Place the button in the desired
position, lower the presser foot
lever.
Removing the presser foot
Raise the presser foot (a).
5. Adjust the stitch width according
Attaching the presser foot
to the distance between the two
Attaching
the
presser
foot
Lower
the presser
foot
holder (b)
until the notch (c) is directly aboveholes
the pin
(d).button.
Lower the
of the
Lowerfoot
theholder
presser
(b) until
(c) is automatically.
presser
(b)foot
andholder
the presser
footthe
(e)notch
will engage
Attaching
the the
presser
foot
directly
above
pin (d).
Lower the presser foot holder
Turn the
counter
Lower
until the
notch (c) is directly6.above
the handwheel
pin (d). Lower
the
(b)
andthe
thepresser
presserfoot
footholder
(e) will(b)engage
automatically.
clockwise to check that the
presser foot holder (b) and the presser foot (e) will engage automatically.
needle goes cleanly into the left
and right holes of the button.
NOTE: Sew at a slow speed to
avoid hitting the button.
LNIS-BLQ2-BS
800-422-2952
www.babylock.com
7. Hold the end of the upper thread gently and begin sewing.
Once sewing is completed, the machine automatically sews
reinforcement stitches then stops.
NOTE: Repeat this procedure to attach the button more
securely.
8. With scissors, cut the upper and bobbin threads at the
beginning of the stitching, pull the upper thread at the end
of the stitching to the wrong side of the fabric, and then tie it
with the bobbin thread.
9. For a 4-hole button, sew the two holes towards the front.
Then raise the presser foot, move the fabric so that the needle
goes into the back two holes, and then sew in the same way.
NOTE: If a shank is required, place a needle or straight pin on
top of the button and sew.
800-422-2952
www.babylock.com