Ecowatt Hotel Card Switch Installation Notes

Hotel Card Switch Installation Notes
DIN MOUNT RELAY
RECEIVER
MODEL: QS-R-S5DIN
40mm
Antenna 83mm
DIN=RAIL MOUNT ONE CHANNEL RECEIVER &
CONTACTOR DRIVER (5A RELAY
85mm
Antenna Housing 105mm
DIN MOUNT RELAY RECEIVER
DB board with DIN Receiver (DB per room)
*NOTE: USE EXTERNAL CONTACTOR TO SWITCH
HEAVY LAODS AS WELL AS FLUORESCENT LAODS
(LOADS EXCEEDING 5A/1000W) E.G. AIRCON,
LIGHTING AND PLUG CIRCUITS
37mm
30M range through
walls and oors
TO LINK CARD SWITCH TO RECEIVER
1. Hold the button down on the side of the receiver till the red LED ashes
2. Insert the card into the switch, the system will then be linked.
to unlink repeat step 1 and 2
Wireless Hotel Card Switch
HOTEL CARD SWITCH INSTALLATION NOTES
CONTACTOR
Hold the receiver LINK button until
the LED starts ashing
CIRCUIT
BREAKER
• Mounrt DIN rail receiver in DB board.
• For best signal strength antenna must be
mounted out of DB board housing
•Antenna must never be cut
Mount Wireless hotel card switch in
most convenient location
POWER
www.ecowatt.co.za | 021 552 4273 | Wilite CC
Insert the card into the switch
within 25 sec to link