JD440-CGRAPPLESKIDOER
Transcription
JD440-CGRAPPLE SKIDOER FEATURES ENGINE PERFORMANCE 70 SAE net hp (71.0 PS) 220 Articulated frame power steering r-- Oscillating front axle 210 TOROUE ~ 200 w is 100 g ~ 6-speed Syncro-Range transmission ...... ........ ""'- 180 Z 170 Front-axle differential lock " l'. Wet-disk power brakes 360-degree rotation of grapple 160 70 55 HORSEPOWER 60 /' " ~ ~ ~ 55 1/ 50 .45 .40 35 ffi 17,600 lb. (7983 kg) maximum lifting capacity " ~ 6 ft. 3 in. (1.91 m) grapple opening ! ~ ~ ~ w z FUEL CONSUMPTION ~ 1200 1400 1600 1800 2000 2200 ENGINE SPEED-RPM 16 I L JD440-C GRAPPLE SKIDDER SPECIFICATIONS (Specifications and design subject to change without notice. otherwise noted, these specifications Wherever applicable, specifications are in accordance with ICED and SAE Standards. Except where are based on a unit equipped with Syncro-Range transmission, 18.4-26, 10-ply logging tires and standard equipment) Power (@ 2200 engine rpm): Gross Net """"""""""" """""""""""" SAE 76hp (56.7kW*) 70hp(52.2kW) 71.0 PS Net engine flywheel power is for an engine equipped with fan, air cleaner, water pump, lubricating oil pump, fuel pump, alternator and muffler. The gross engine power is without fan. Flywheel power ratings are under SAE standard conditions of 500-ft. altitude and 85° F. temperature, and DIN 70 020 conditions (non-corrected). No derating is required up to 10,000 feet (3000 m) altitude. 'In the international system of units (SI) power is expressed in kilowatts (kW). Engine: John Deere 4-cylinder-diesel, 4-stroke cycle Bore and stroke .4.19x5.00 in. (106.4x127 mm) Piston displacement. . . . . . . . . . . . . . . . .276 cu. in. (4523 cm3) Compression ratio 16.7t01 Maximum torque @ 1200 rpm 220 Ib-ft (298 Nm) (30.4 kg-m) NACC or.AMA (U.S. Tax) horsepower .28 Lubrication .Pressure system w/full-flow filter Cooling. . . . . . . . . Pressurized w Ithermostat and fixed bypass Fan Blower Air cleaner wi restriction indicator. . . . . . . . . . . . . . . . . . . . . Dry Electrical Batteries system. . . . . . . . . . . . . . . . . . . . .12-volt wi alternator (2) . . . . . . . . . . . . . . . . . Reserve capacity: 410 minutes Differentials: Front.. . . . . . . . . . . . . . . . . . . . Full Rear differential w/hydraulic lock .Solid axle wino differential action Transmission: Syncro-Range Constant mesh with 6 speeds forward, 3 reverse. Three forward speed ranges with synchronized shifting between low and high within each range. Incorporates a brake lock for service brakes. Clutch is 11 in. (280 mm), dry, feramic-faced, footpedal-operated. Travel Speeds (2200 engine rpm, no tire slip): Forward: 2 mph (3.2 km/h) to 15 mph (24.1 km/h) Reverse: 2 mph (3.2 km/h) to 10 mph (16.1 km/h) Brakes: Hydraulic power actuated, wet-disk service brakes on output shaft. Hand-operated mechanical brake for parking. Drive Axles: Four-wheel drive with inboard planetary gears on all axles. Front axle oscillates 15 degrees above and below horizontal. 18 in. (457 mm) total travel at tire center line. Power Steering: Articulated frame hydraulically actuated by dual cylinders. Turning radius 17ft.8in.(5.38m) Turning clearance ... ... .37ft.1 in. (11.30m) Hydraulic System: Closed-center constant pressure. Variable-displacement pump driven from crankshaft .25 gpm (95I1min), 2000 psi (137.9 bar) (140.6 kg/cm2) @ 2200 engine rpm. Full flow filtration. Oil to air cooler. Hydraulic Cylinders: Bore Stroke Lift (2) 4.0in.(102mm) 30in.(762mm) Grapple (1) . . . . . . . . . . . . . . 5.25 in. (133 mm) 17 in. (432 mm) Cylinder rods. .Ground, heat-treated, chrome-plated, polished Lift cylinder rods 2-in.(51 mm)dia. Grapple cylinder rod .2.25 in. (57 mm) dia. Tires: 18.4-26, 10-ply-rating, logging, LS2 16.9-30, 10-ply-rating, logging, LS2 Capacities: Fueltank Cooling system Engine , U,S. 42gal. 8gal. lubrication, including filter. . . . . . . . . .15 qt. Transmission case (includes hydraulic system) 8 gal. Front differential 4.5gal. Reardifferential 4.5gal. Winch 2.5gal. Liters 159.0 30.3 14.2 30.3 17.0 17.0 9.5 Additional Standard Equipment: Flanged axles Ether starting aid Muffler Engine side shields Fuel gauge Deluxe seat w/suspension Oil pressure gauge Roll-over protective structure Alternator charge (RaPS) wi canopy, seat belt, warning light. brush screens, & limb risers Water temperature gauge Transistorized voltage Lights regulator John Deere winch Vandal protection Front axle dilferentiallock Altitude compensator Electric hourmeter Key switch w/push-button safety start Cigaret lighter Horn Fire extinguishers (2) Foot throttle Hand throttle Front blade Winch: Live mechanical drive; hydraulically actuated clutch and brake. Single-lever control. Cable capacities*: Y2-in. (12.7mm) cable 2301t.(70.1 m) 5/a-in. (15.8mm) cable 1511t.(46.0m) 3,4-in.(19.1 mm)cable 1071t.(32.6m) 'Calculated: No allowancemade for loose or uneven spooling. Line pull (1600 rpm)*': Bare drum. . . . . . . . . . . . . . . .22,200 lb. (99.5 kN) (10070 kg) Full drum 13,700Ib.(61.4kN)(6214kg) "Based on engine torque. Line speed (2200 rpm): Bare drum Fulldrum 119fpm(36.3m/min) 194Ipm(59.1m/min) Blade: Hydraulic control Width 6ft.(1.83m) Height (ends) 11t.8in.(508mm) Height (center) 21t.3in.(686mm) Max. lilt above ground level. . . . . . . . . . . . . . . . . . .4 It. (1.22m) Max. drop below ground level. . . . . . . . . . . . . .9.5 in. (241 mm) SAE Operating Weight. . . . . . . . . . . . . . . . .16,525 lb. (7496 kg) Special Equipment: Wheel weights Steering accumulator Engine coolant heater Cab with heater and noise treatment Windshield with wiper 3 in. (76 mm) seat belt Log arch with adjustable rollers 17 JD440-C GRAPPLE SKIDDER DIMENSIONS Sideview dimensions are for Skidder equipped with 18.4-26 tires, grapple open. r 9 ft. 4 in. (2.84 m) ~;::::-<~~::: II 1 ':, ~-' I u":i.-~ ::'..~.~. "",;:,g;; ;,,1', lHHiii!! .q~-" II" .E ::;""-~I It~ " "II =C\J :: A! II v"!.... :~~:: :::::::::" '-'..\ '1'--" -'"/' --- '-, ;::",-,/.--f -~.I I i:" 111111 :11:: " 111"" iii,i::: ",,"" ""::i; -'~~"-- ::1:1 ::.J: 2 ft. 7 in. (788 mm) :::::: -1-::iJ 1 i; "'~:'--~ iW 6ft. 11in. (2.11m)-I- 9.5 in. (241 mm) 106in. (2.69m) 19 ft. 11 in. (6.07 m) " --- "--'- " --, -- " \\\ \J , I I I ..lL' .f' B 5 in, (127 mm) A G TIRE SIZE A WHEEL TREAD 6 ft. 3 in. (1.91 m)--j B GROUND CLEARANCE C OVERALL WIDTH 16.9-30 74 in. (1.88 m) 1 ft. 7 in. (483 rom) 7 ft. 7 in. (2.31 m) 18.4-26 74 in. (1.88 m) 1 ft. 6 in. (457 rom) 7 It. 8.4 in. (2.35 m) 18 t
Similar documents
jd440-c skidder
Transmission case (includes hydraulic system) 8 gal. Front differential """""""""""'" 9gal.
More information440B tractor
Front axle oscillates 15 degrees above and below horizontal. 18 in. (457 rom) total travel at tire center line. Power Steering: Articulated frame hydraulically actuated by dual cylinders. Turning r...
More information644B - John Deere
gross engine power is without fan. Flywheei power ratings are under SAE standard conditions of 500-ft. aititude and 85°F. temperature and DiN 70020 conditions (non-corrected). No derating is requir...
More informationJD440-BSKIDDER
driven from crankshaft. . . .28 gpm (106 Ipm), 2.000 psi (140,6 kg/cm2) @ 2,500 engine rpm.
More information440d skidder
276cu.in.(4.524L) Maximum net torque @ 1300 rpm . . . 253 Ib-ft (343 Nm) (35 kg-m) Cooling fan Blower Compressionratio 16.8t01 Lubrication. . . . . . . . . . . . . . . . . Pressure system w/full-fl...
More informationJD440SERIES-ASKIDOER
Suction fan Hydraulic system Engine side-shields Power steering Power brake Air cleaner (dry type) Muffler 140-amp. hour battery installation (two 70 amp. batteries) Fuel gauge Canopy Oil-pressure ...
More information