The Bouglé - AuSable River Two Fly Shop
Transcription
The Bouglé - AuSable River Two Fly Shop
The Bouglé BOUGLÉ FLY REEL The first Hardy Bouglé reel was catalogued in 1903, and was, as it remains to this day, a variation on the famous Hardy Perfect reel. The variation was initially requested by Frenchman Louis Bouglé, an extremely knowledgeable fisherman and tournament caster who requested that Hardy produce a reel with a good line capacity which remained light enough to balance rods between 41/2oz and 8oz. From this initial request, the Bouglé reel went from strength to strength and became one of the most famous reels in angling history. Now, 110 years later, we at Hardy Bros., Alnwick are proud to offer a new variant of the Bouglé reel which we feel is one of the best yet—with its rolling pillar; reversible click check; naval brass bush and spindle; and its hand polished, deep anodised ‘pearl silver’ finish. This Bouglé reel is sure to become one of the classics. Made by time served Hardy Bros. reel makers here in Alnwick, England, this Bouglé reel comes presented in a beautiful, UK made, soft leather, sheepskin lined reel case. CARE & MAINTENANCE 1. Remove line and backing. 2. Remove the spool. 3. Flush away dirt by placing the spool and frame under a stream of fresh water. 4. Dry carefully with a lint free cloth. 5. Lubricate with a good quality oil at the points illustrated on the diagrams. 6. Always ensure the spindle is adequately greased. 7. Always turn the click-check to the minimum setting to avoid compression of the springs. 8. Always ensure the reel and line are dry before storing in the case or pouch. Grea Grea Oil Grease Oil Grease Grease Revolving Pillar Grease Revolving Pillar REVOLVING PILLAR MAINTENANCE Pillar Screw PILLAR MAINTENANCE REVOLVING Pillar Grease Pillar Screw Grease Pillar At least once per season, remove the pillar screw using a good fitting screwdriver. Using a good quality At least once per season, removethe water repellant grease, lubricate the pillar screw using good fitting shaft of the screw anda replace. screwdriver. Using a good Wipe off any excess with aquality cloth. water repellant grease, lubricate the shaft of the screw and replace. Wipe off any excess with a cloth. REMOVING THE SPOOL Spool dismantling procedure 1. Remove the locking screw using a good fitting coin or screwdriver, turn locking screw clockwise to remove. 2. Rest the palm of your hand against the face of the spool, turn winding plate anti-clockwise to remove from spool. The spool, winding plate and frame should all be seperated at this point. To re-assemble the spool please reverse the above dismantling procedure. Frame Wind Plate Grease Spool BOUGLÉ CLICK-CHECK MECHANISM The click-check mechanism can be adjusted by simply turning the regulator wire on the side of the frame, anti-clockwise to increase the check, clockwise to decrease the check. When the reel is not in use, the check should be turned to the minimum setting (not applicable to the Bouglé Baby model). Regulator Wire REVOLVING PILLAR MAINTENANCE Pillar Screw rease Revolving Pillar e per season, remove ew using a good fitting Using a good quality nt grease, lubricate the screw and replace. excess with a cloth. Pillar At least once per season, remove the pillar screw using a good fitting screwdriver. Using a good quality water repellant grease, lubricate the shaft of the screw and replace. Wipe off any excess with a cloth. LEFT TO RIGHT WIND CONVERSION All Bouglé reels are designed to work in right or left hand wind. When you receive your reel, it will be set for left hand wind. 1. Remove the plate and spool out of the frame by following the spool dismantling procedure described previously. Stop Screw (4” model only) Left Hand Tongue 2. Pick up the frame so that the mechanism is visible. 3. Remove stop screw and collar from above LH tongue (4” model only). Right Hand Tongue 4. Using your thumb and forefinger, switch the left hand tongue into the off position. 5. Using your thumb and forefinger, switch the right hand tongue into the engaged position. Stop Screw (4” model only) 6. Replace stop screw and collar above RH tongue (4” model only). 7. Replace the plate and spool on to the frame – your reel should now be right hand wind. This frame is shown in Left Hand Mode This frame is shown in Left Hand Mode Left Hand Tongue Right Hand Tongue This frame is shown in Right Hand Mode This frame is Right Han SPECIFICATION Code Reel Extreme Diameter (inches) Weight (g) Capacity (m) HEB010 Baby Bouglé Reel 213/16 90g DT2+25m HEB020 3" Bouglé Reel 3 102g DT2+70m HEB030 31/4" Bouglé Reel 31/4 116g DT4+100m HEB040 31/2" Bouglé Reel 31/2 133g DT6+70m HEB050 4" Bouglé Reel 4 225g DT10+225m Code Spool HSB010 Baby Bouglé Spool HSB020 3" Bouglé Spool HSB030 31/4" Bouglé Spool HSB040 31/2" Bouglé Spool HSB050 4" Bouglé Spool WARRANTY All Hardy Bros. Bouglé reels carry a lifetime original owner warranty against any defect in workmanship or materials. Should there be any defect, Hardy will, at its discretion, repair or replace the item. This warranty does not cover damage caused by misuse, lack of maintenance, negligence or normal wear and tear. Warranty claims with the proof of purchase should be sent FAO Customer Services Department to: Hardy & Greys Limited Willowburn, Alnwick Northumberland NE66 2PF England Hardy North America 1260 Corporate Boulevard West Hempfield Township Lancaster, PA 17601 United States of America Hardy & Greys GmbH Brägeler Forst 7 D-49393 Lohne (Oldenburg) Germany Tel: +44 (0)1665 602771 Fax: +44 (0)1665 602389 Tel: +1 (717) 537 3900 Fax: +1 (717) 537 3905 Tel: +49 (0) 44 42–80 29 20 Fax: +49 (0) 44 42–80 29 229 www.hardyfishing.com sales@hardyfishing.com www.hardyfishing.com info@hardyna.com www.hardygreys.de verkauf@hardygreys.com Fine fishing tackle since 1872 Hardy & Greys Limited Willowburn, Alnwick, Northumberland NE66 2PF England Tel: +44 (0)1665 602771 www.hardyfishing.com