User Manual - Aqua Bed Warmer

User Manual
Published By
Firstech, LLC
21903 68th Avenue South
Kent, WA 98032U.S.
Tel: 1-888-820-3690
www.aqua-bedwarmer.com
© 2012 Firstech LLC. All rights reserved.
www.aqua-bedwarmer.com
Table of Contents
Welcome .......................................................................................................................03
Two-Pronged Grounded Plug.............................................................................03
Important Safety Precautions .............................................................................04
Standard Components ...........................................................................................05
Getting Started ...........................................................................................................06
Before First Use .....................................................................................................06
Initial Setup .............................................................................................................06
System Operation .....................................................................................................07
Temperature Units (Fahrenheit/Celsius) ....................................................07
Setting Operating Time ....................................................................................07
Time Options .........................................................................................................07
Setting Operating Temperature .........................................................................08
Temperature Options .........................................................................................08
Safety Features ......................................................................................................08
Cleaning and Storage .............................................................................................09
Water Replacement ............................................................................................09
Troubleshooting ........................................................................................................09
Error Codes .............................................................................................................09
Product Registration ..........................................................................................10
Warranty Policy .....................................................................................................10
Aqua BedWarmer Support ..................................................................................11
03 User Manual
English 04
Welcome
Important Safety Precautions
The Aqua Bed Warmer provides outstanding comfort by adding warmth to
your night’s rest. Find relaxation with your Aqua Bed Warmer using the water
you already have at home. The Aqua Bed Warmer utilizes a system of sturdy
tubing that distributes heated water evenly throughout the connected pad.
With a wide range of temperature selections, the bed warmer offers control
over the level of warmth at your disposal.
1.
2.
3.
4.
5.
6.
7.
Two-Pronged Grounded Plug
ATTENTION
This unit features a two-pronged grounded plug. To reduce the risk of
electric shock, do not attempt to insert the plug into any outlet other than a
US household outlet with a ground slot.
Do not attempt to modify the plug, as this can cause serious damage to the
unit and to the household electrical system.
Carefully read all instructions before handling product.
Do not handle system when hands are wet.
Do not immerse system or any system component in water.
Plug the power cord in an 120V US power outlet only.
Do not pull the cord at the wire, pull at the grip.
Do not operate with damaged cord or any other damaged component(s).
Use only water with the system (purifiedwater is preferred); do not add any
other types of liquid.
8. Pour water slowly in the unit.
9. Unplug the outlet when cleaning and/or replacing unit water.
10. Use extreme caution when handling hot water from the system.
11. Only use the manual pump provided with the unit to release excess water
from the hose system.
12 Do not use the pump for anything other than the hose when disconnected from the heater unit.
13. Do not attempt to add water into the hose system.
14. Do not place sharp objects near any component.
15. Shutoff the system immediately if any water is found near any component.
16. Use the system indoors only.
17. Place unit on firm, flat surface.
18. Do not place the mat more than 2 feet higher than the boiler.
19. Do not add water when indicator displays full tank.
20. Do not move unit around electrical systems.
21. Keep away from children.
English
English
06
05 User Manual
Standard Components
Heater Unit
Cable Mat
Getting Started
Pump
Before First Use
1. Read and review all safety information and product guidelines.
2. Inspect all product components for factory defects.
3. Dispose of product packaging components properly.
Initial Setup
Power Adapter Input
Safety Surface Pin
Hose Connector
Water Level
Temperature
Time Display
Status Display
Temperature Button
Power Button
Time Button
1. Connect the hose assembly to the heated water
connector at the rear of the unit. There is no
dedicated input or output allowing both hoses to
be inserted into either connector.
2. Open the cap at the top of the unit by turning
the handle counterclockwise until the cap unfastens.
3. Carefully pour water at room temperature into
the opening at the top of the unit. Pour until
the water level reaches the inside of the small
filler assembly. For further assurance, the LCD
will display the water level inside.
4. CAUTION – Excess water may release from the
center of the cap.
5. Secure the cap by turning it clockwise.
07 User Manual
English 08
System Operation
Setting Operating Temperature
Temperature Units (Fahrenheit/Celsius)
1. To change the unit of temperature on the display,
press the POWER button to deactivate the system.
2. Press TEMP to switch between degrees Fahrenheit or Celsius.
3. Press POWER to reactivate the system.
Setting Operating Time
1. With the unit ON, the display will indicate the
current temperature of the system.
2. To view the set operating time, press TIME.
The display will indicate the number of hours the
system will continue to operate at the set
temperature.
3. To change the operating time, press TIME until the projected operating
time is displayed and then the UP or DOWN arrows until the desired number
of hours is reached.
1. With the unit ON, the display will indicate the
current temperature of the system.
2. To view the set operating temperature, press
TEMP. The display will indicate the projected
temperature in either Fahrenheit or Celsius,
according to the current setting.
3. To change the operating temperature, press TEMP until the projected
operating temperature is displayed and then the UP or DOWN arrows until
the desired temperature is reached.
Temperature Options
Minimum
Default
Maximum
68°F
( 20°C )
113°F
( 45°C )
158°F
( 70°C )
Safety Features
Time Options
Minimum
Default
Maximum
1 Hour
12 Hours
24 Hours
to prevent freezing.
09 User Manual
English 10
Cleaning and Storage
Water Replacement
1. IMPORTANT – Disconnect the power from the unit
before removing or replacing any water in the system.
2. Place system directly above a large, open container.
3. Dispense the water from the pump system by
twisting both hoses counter-clockwise and disconnecting the hoses from the assembly.
4. Dispense the water from the mat by inserting the
pump into either hose then pushing and pulling the
handle until the water is forced out of the opposite hose.
5. Follow the instructions in “Initial Setup” to add water
into the system.
Troubleshooting
Error Codes
Code
Description
Troubleshoot
E1
E2
E3
E4
Low Water Level
Temperature Sensor
Circulation Pump
Heater
Insert Water
Contact Support
Contact Support
Contact Support
E5
System Overheat
Contact Support
E6
Water Level Sensor
Contact Support
Product Registration
This product must be registered within 10 days of purchase to validate war
-ranty. To register, complete and return the included warranty registration
card or register online at www.aqua-bedwarmer.com.
Warranty Policy
Aqua BedWarmer comes with a 2year limited warranty from the date of
purchase for the original owner. The product must be registered within 10
days to validate warranty. If a defect in the heater unit and/or mat arises, the
item(s) may be replaced under warranty. Unit(s) exhibiting damage and/or
evidence of unauthorized modification will be void of warranty coverage.
Aqua BedWarmer Support
21903 68th Avenue South
Kent, WA USA 98032
Phone: (888) 820-3690 #112
Email: warranty@aqua-bedwarmer.com
Web: www.aqua-bedwarmer.com