GW 031A - GULIWER Electronics

CONTACTLESS
WATER CONTROL
AUTOMATIC SHOWER CONTROL
GW 031A
water saving
high hygiene
contactless water control
non-sensitive to ambient light
non-reactive to people accidentally
moving near the flusher
PROPERTIES
reacts to presence of person standing in front of the sensor in distance to 0,5 m with
automatic rinsing after 1 s
water flow still 3 s after exit from the shower
non-reactive to people accidentally moving near the sensor
adjustable closure sensitivity
the equipment is not determined for the assembly opposite to each other
Instructions for parametrs adjustement:
- this type isn't intended for parameters remote control, parameters adjustment by trimmers
Technical data
Stainless steel cover
Necessary installation pocket
Supply voltage
Power input
Range
Recomanded working pressure
Water flow
Water inlet
Water outlet
174 x 174 x 10 cm
150 x 150 x 80 cm
AC 20 V
1,2 W (state of rest)
10,7 W (during closure)
0,5 m
0,1 - 1 MPa
12 l/min.
external thread G 3/4“(1/2“)
external thread G 3/4“ (1/2“)
Guliwer electronics, s.r.o., Dukelských hrdinù 1011, 563 01 Lanškroun, Czech Republic
Tel./fax: +420 465 461 535 (sale) +420 465 461 536 (techn. information)
Mobil: +420 603 162 962; +420 603 843 695; e-mail: guliwer@guliwer.cz; http: //www.guliwer.cz
Wiring and assembly diagram
1 - supply water pipeline
2 - stainless steel cover with electronics
3 - mounting frame, connecting nut
4 - sensor sensing zone
5 - spray jet shower
6 - power supply
7 - electromagnetic valve
8 - outlet pipe
Recommendations for installation
- water and electro installation (in the case of connection with main supply) must
agree with specified technical standards and can be made only by professionally competent
person
- device is installed into the installation pocket under the spray jet shower in height cca 130 cm
on its center line
- the device isn't determined for the assembly opposite to each other
- before connection to the water distribution, it's recommended to flush water supply from dirts
and deposits (in order to prevent possible damage of electromagnetic valve)
- the mode of installation is evident from the enclosed diagram
- the sensor sensitivity will be adjusted by the trimmer on the rear side of electronics
- is recommended to seal the cover by the filler
Recommended accessories
GW 091Z
GW 092Z
- external power supply 230/20 V AC, for simultaneous
feed of max. 3 shower controls
- external power supply 230/20 V AC, for simultaneous
feed of max. 5 shower controls
Guliwer electronics, s.r.o., Dukelských hrdinù 1011, 563 01 Lanškroun, Czech Republic
Tel./fax: +420 465 461 535 (sale) +420 465 461 536 (techn. information)
Mobil: +420 603 162 962; +420 603 843 695; e-mail: guliwer@guliwer.cz; http: //www.guliwer.cz