TMS4710 - Trenton Systems

Transcription

TMS4710 - Trenton Systems
TMS4710
TRENTON 4U MIL-STD 2-in-1 RACKMOUNT COMPUTER
FEATURES
Copyright ©2009 by TRENTON Technology Inc.
All rights reserved
· Designed to fit a wide variety of mission requirements
· Rugged yet lightweight corrosive-resistant aluminum chassis
· Two system host boards and backplanes reduce rack space while
·
Trenton TMS4710 2-in-1 Rackmount Computer
Shown with a two small form factor backplanes and SHBs
·
·
·
·
delivering system application flexibility and performance
System host boards (SHB) support long-life, multi-core Intel®
processors with native PCI Express support
Supports plug-in PCI Express and PCI option cards
Over 900GB of SLC memory capacity with up to four SSDs (2, SSDs per segment)
MIL-STD-810G certifications for a wide variety of harsh environments
MIL-STD-461F certifications for EMI/RFI emissions
TMS4710 CONFIGURATION SUMMARY:
The Trenton TMS4710 is a, 4U, two-in-one rackmount computer that has been certified to a wide variety of military environmental and electrical standards. This dual rackmount computer carries
various MIL-STD-810G and MIL-STD-461F environmental and electrical emissions certifications for a system configuration consisting of; 2 – BXTS7059 PICMG 1.3 system host boards (SHBs), 2 –
IOB33JX I/O expansion board (one each installed on the BXTS7059 SHB), 2 – BPC8114L PICMG 1.3 small form factor backplanes, and multiple Mil-Std-1553B and ARINC 429 plug-in I/O cards.
The TMS4710’s two independent ATX auto-ranging power supplies ensure and dual SHB/backplane system architecture ensures complete, and independent operations that enables secure
application software segmentation.
The TMS4710 is factory configured with (1) 2 ½” front access/removable drive bay and (1) 2 ½” internal drive bay per system backplane segment. For the mil-certified TMS4710 configuration,
four solid state disks (SSD), each with a 240 GB SLC memory capacity, are installed in the system along with two DVDs. Other “designed-to-meet” TMS4710 system configurations are available.
TMS4710 SYSTEM LAYOUT:
Segment #A
Segment #B
Rear
View
SSD - B
SSD -A
Segment #A
R/W DVD -A
Power Supply B
Power Supply A
Segment #B
R/W DVD - B
7.00”
(17.8cm)
Hold-down Bar for the SHBs and Option Cards
23.0”
(58.4cm)
SHB B
SHB A
24.79”
(63.0cm)
Backplane A
Backplane B
Front View (Door Open)
19.0”/(48.3cm)
18.24/(46.1cm)
4.00
(10.2cm)
Segment #A
Side View
Top View (shown with some typical pre-installed cards)
7.00
(17.8cm)
Segment #B
Front View (Door Closed)
4U MIL-STD Two-in-One Rackount Computer: TMS4710
SYSTEM MODEL
TMS4710
DESCRIPTION
4U rackmount MIL-STD-810G/MIL-STD-461F rackmount computer featuring two small form factor backplanes, two system host boards, up to two SSDs
per system segment. Also supports pre-installed MIL-STD-1553B I/O cards and data communication cards.
TRENTON Systems Inc. 2350 Centennial Drive, Gainesville, Georgia 30504 Sales: (800) 875-6031 Phone: (770) 287-3100 Fax: (770) 287-3150
E-mail: Sales@TrentonSystems.com Web: www.TrentonSystems.com
TECHNICAL SPECIFICATIONS:
MODEL NAME
TMS4710
DESCRIPTION
4U, MIL-STD-810G/MIL-STD-461F tested, rackmount computer with two system host boards and two small form factor backplanes in a rugged aluminum chassis coated per MIL-DTL-5541
SYSTEM HOST BOARDS
MIL-STD Certified SHB Configuration: 2 - Single Processor - BXTS7059 SHBs with each board using an Intel® Xeon® E5-2448L long-life processor
Alternate SHB Configuration Options: Dual-Processor BXT7059 or JXT6966 SHBs, Single-Processor THD8141, TSB7053 or JXTS6966 all with long-life Intel®processors
BACKPLANES
MIL-STD Certified Backplane Configuration: 2 - Small form factor BPC8114L backplanes supported using independent power supplies to drive each backplane
Alternate Backplane Configuration Options: 2 - Small form factor BPX5, BPG4, BPX3/2, or BPG2/2 backplanes
SHOCK & VIBRATION STANDARD
Mechanical Shock - MIL-STD-810G, Tested to Method 516.6, Procedure I, functional, sawtooth, 40G, 11ms, 3 per axis
Vibration - MIL-STD-810G, Tested to Method 514.6, Procedure I, Category 4, operating, 10-500Hz & MIL-STD-810G, Method 514.4, Category I
OPERATING TEMPERATURE STD.
High Temp. - MIL-STD-810G, Tested to Method 501.5, Procedure II (operational), 55º C. for 2 hours after temperature stabilization
Low Temp. - MIL-STD-810G, Tested to Method 502.5, Procedure II (operational), -10º C. for 2 hours after temperature stabilization
STORAGE TEMPERATURE STD.
High Temp. - MIL-STD-810G, Tested to Method 501.5, Procedure I (storage), 71º C. for 2 hours after temperature stabilization
Low Temp. - MIL-STD-810G, Tested to Method 502.5, Procedure I (storage), temperature soak at -51º C. for 2 hours after temperature stabilization
HUMIDITY STANDARD
MIL-STD-810G, Tested to Method 507.5, Procedure II, Figure 507.5-7, exposed to 23º C./50%RH for 24 hours then subjected to 10 cycles of
24-hours where temperature changes between 30º C. and 60º C. while maintaining a relative humidity of 95%
ALTITUDE STANDARD
Operational - MIL-STD-810G, Tested to Method 500.5, Procedure II, 15,000 ft./4,570 m. for 1 hour after stabilization
Storage - MIL-STD-810G, Tested to Method 500.5, Procedure I, 15,000 ft./4,570 m. for 1 hour after stabilization
EMI/RFI EMISSIONS STANDARD
MIL-STD-461F, Methods CE101, CE102, CS101, CS114, RE101, RE102, RS101, RS103 and CS116
SYSTEM SAFETY STANDARD
No known safety or operating hazards as per an in-depth analysis of the MIL-STD-882 standard and the system design of the TDP4720
DRIVE BAYS
4 total drives are supported via 1 - front removable 2.5” SSD carrier and 1 - internal 2.5” SDD in each SHB segment (4 total SSDs)
1 Slim-Line R/W DVD is also supported in each SHB segment (2 total R/W DVDs)
POWER SUPPLY
One system power supply per segment: 115-240VAC, 50-400Hz, 520W
COOLING
3 - 92mm front access 102CFM, and 4 - 25.4mm rear access 60CFM fans each with chassis temperature monitoring speed control
SWITCHES
Power On/Off and Reset for each SHB segment
INDICATORS
Front-panel LEDs for HDD/SDD activity, Power, and Fan Status for each SHB segment
ENVIRONMENTAL SPECIFICATIONS
Temperature: -10º C to 50º C system operating temp. with a 0º C to 45º C typical SHB operating temp @ 350LFM across each segment’s SHB, and
-30º C to 70º (storage), Humidity: 5% to 95% non-condensing
DIMENSIONS
19.0”/ 48.26cm (W) x 7.0”/17.78cm (H) x 23.0”/58.42cm (D)
CHASSIS NET WEIGHT
55.8Lbs. (25.3Kg.) - Includes two BXTS7059 SHBs with IOB33 modules installed, two shoebox form factor backplanes, plus five pre-installed device interface cards
NOTES:
1. The chassis photos are shown for illustrative purposes only.
Trenton Systems offers complete system integration of a wide variety of standard and customer
supplied operating systems and application software packages. Various Microsoft®, Linux and
RTOS operating systems can be loaded on to your system by our highly skilled factory
technicians. Other system integration services include loading and testing of industry standard
or COTS option cards as well as custom designed boards.
Copyright ©2009 by TRENTON Systems Inc.
All rights reserved
PICMG is a registered trademark of the PCI Industrial Computer Manufacturers Group. Microsoft is a registered trademark
of Microsoft Corporation. All other product and/or company names are trademarks or registered trademarks of their
respective owners.
Copyright ©2015 by TRENTON Systems Inc., All rights reserved
Standard industry certifications and approvals for your specific system configuration are also
available from Trenton Systems.
Final system weight, environmental specifications and total power consumption estimates are a
function of the specific system configuration. Preliminary estimates and final validated values
are provided by Trenton for each rackmount computer system we build.
TRENTON Systems Inc. 2350 Centennial Drive, Gainesville, Georgia 30504 Sales: (800) 875-6031 Phone: (770) 287-3100 Fax: (770) 287-3150
E-mail: Sales@TrentonSystems.com Web: www.TrentonSystems.com
8414720
04025 1.0

Similar documents

Datasheet for the THS5090 HDEC Series 5U

Datasheet for the THS5090 HDEC Series 5U The Trenton THS5090 is an HDEC Series 5U rackmount computer that features two HEP8225 HDEC Series system host boards and two HDB8236 backplanes. Each backplane/SHB combination or segment, operates ...

More information

msd-v3 maintenance support device - version 3

msd-v3 maintenance support device - version 3 Type II or 1x Type III, Express Card/54, Smart Card, optional 802.11 a/b/g/n wireless; optional embedded dual 1553 or embedded second RS-232/422/485; Upgradeable EFI BIOS PERIPHERALS: DVD+RW/CD-RW;...

More information