GSM Gateway – ProLine-Digital

Elexim Sofia ”Tcarigradsko Shoses” blvd. 7th km. BIC-IZOT office 314
Tel.: 02 9718880, 0896757070 office@elexim.com; www. elexim.com
GSM Gateway – ProLine-Digital
Users Manual
GSM Gateway is designed to plug in to telephone exchange or to phone. It makes a simply
analogue line with standard parameters. (impedance of the line is 600 Ohm).
Installation
–
–
–
–
put the SIM card (without PIN code) in GSM Gateway
switch the antenna
connect the cable from GSM Gateway line jack to the PBX or phone
switch the power supply.
LED indication
– red led flashing – status ready
– green led – light permanently when pick up the phone handset and flashing when make outgoing
call.
Adjustment:
If you want to change one or more parameters of GSM Gateway Proline-Digital you can do it with
specialize software which can be found on the CD.
How to make the adjustments:
1.connect the USB cable to your PC and GSM Gateway.
2.Check on which COM port the GSM Gateway is connected.
3.Change the file *.bat with the right COM port.
4.Change the settings in *.txt file as you wish and save the file.
5.Start *.bat file to load the new settings to GSM Gateway.
Technical Parameters
Telephone line:
– analogue, RJ11, tone dialing
– polarity reverse
– 2 frequency signal dial
– line protection from short circuit
– Caller ID (FSK)
– impedance 600 Ohm
GSM:
–
–
–
–
–
frequency range - GSM 850 / 900 / 1800 / 1900 MHz.
SIM Card -3V plug-in
output power: class 4 (2 W) for EGSM 850/900; class 1 (1 W) for GSM 1800/1900.
CLIP; CLIR;
antenna – SMA coupling, 3 meter cable length, impedance 50 ohm
Power Supply:
– adapter 220V AC/12V,500 mA
– consumption in stand by mode – 110 mA
– consumption in working mode – 300 mA
General features:
– dimensions: 120/60/30 mm
– weight: 200 gr.
– Interface - USB v.1.0 type B connector
– working temperature: 0 - 45 ° C
– humidity: 10% to 90%
– CD with software
2 years guarantee