Baby Walker

Baby Walker
Instruction manual
Conform to EN1273:2005
Complies with standards ASTM F977-03
STANDARDS
Nr
Parts list
Quantity
1
Chassis
1pcs
2
Seat Pad
1pcs
3
Seat Support
1PC
Toy tray
1pcs
5
Anti-slippery
4pcs
6
Mirro
Mirrorr
2pcs
7
Tail panel
1PC
8
Large wheel
2Sets
9
Wheel
2sets
Picture
4
1.Unpack all contents and please check that all parts are present before starting
assembly. Please see PARTS LIST
2.To open the baby walker
walker,, raise the tray to the middle position as shown in figure 1.
Figure 1
3. Assemble the four wheels as illustrated.
Figure 2
4. Assemble the tail panel as illustrated.
Figure 3
5. Assemble the mirror as illustrated.
Figure 4
6. Assemble the backrest panel as illustrated.
Figure 5
7. Push crotch portion of seat pad inside out to form seat, so the fabric is on inside of pad.
Figure 6
8. Insert the 8 round tabs on the seat pad into slots located around the seat ring, slide tabs
through holes. Turn tray up side down. Pull tabs and align into grooves. You may have to
push tabs from top of walker to properly Fasten.
Figure 7
9. Test: Push down hard on seating area of seat pad to make sure seat is securely in place.
CAUTION: Do not use walker if all tabs are not secured properly, otherwise child may
fall through walker.
Figure 8
10
10.. Place walker on a solid flat surface with bottom of base facing upward. Insert the
pins of the wheels into their housing, pressing them until they snap into position.
Please check that wheels are locked into place as figure 9 and figure 10
10..
Figure 9
Figure 10
11
11.. Turn base up side down, insert the strips properly with middle post and the both
e in use.
side post as figure 11. Be sure the strips attached to the bas securely befor
before
Figure 11
s, remove
14
14.. The baby walker can be used for 3 different heights. To adjust height
heights
baby from walker. Turn the safety button lengthwise and press the safety button until
the mechanism is released. Adjust to des
desiired height as shown in figure 12
12..
Figure 12
15
15.. When the position has been selected, check that the safety button turned through
90 degrees to prevent the accidental release of the mechanism as shown in figure 13
13..
Always follow this procedure. Never use the baby walker if the button is not in the
sideways position. Important: Never change the he
heiight when the baby is in the walker.
Figure 13
.Toy tray requires 2 "AAA" batteries (not included). Please use Philips head
16
16.Toy
screwdriver to unfasten battery cover. Insert battery as figure 14
14.. Secure battery cover
back. Caution: Old and new batteries(alkaline standard or rechargeable )should not be
mixed in use
use.. Remove battery before storing the toy tray.
Figure 14
WARNING --- Never leave the child unattended
WARNING
The child will be able to reach further and move rapidly when in the baby walking
frame:
I) Prevent access to stairs, steps and uneven surfaces;
2) Guard all fires, heating and cooking appliances;
3) Remove hot liquids, electrical flexes and other potential hazards from reach;
4) Prevent collisions with glass in doom, windows and furniture;
5) Do not use the baby walking frame if any components are broken or missing;
6) This baby walking frame should be used only for short periods of time (e.g. 20 main);
7) This baby walking frame is intended to be used by children who can sit unaided, approximately
from 6 months. It is not intended for children weighing more than 12 kg;
8) Do not use replacement parts other than those approved by the manufacturer or distributor;
9) Instructions for routine maintenance and cleaning or washing.
IMPORTANT SAFETY INFORMATION:
Always keep child in view while USING WALKER.
CAUTION: Toys intended to be assembled by adult!
STAIR HAZARD
Avoid serious injury or death. Block stairs & steps securely before using this walker.
Use only on flat surfaces free of objects that could cause this walker to tip over. Never use near
stairs, steps, thresholds, hills, roadways, or pools.
To avoid burns, keep child away from hot liquids, stoves, radiators, space heaters, fireplaces, etc.
Discontinue using this walker should it become damaged or broken
Never carry this walker with child in it. Never adjust seat while child is in product.
~ DO NOT lift or carry by tray, toy tray, or toys.
~ DO NOT use this walker until baby can sit up unassisted.
~ To reduce the chance of child slipping out of seat, check that both feet of child touch the floor.
~ Discontinue using this walker when your child can stand unaided or walk unassisted.
Only use this walker if your child MEETS ALL of the requirements below:
1. Can support body weight with legs
2. Weight is between 15 and 25 pounds (6.8 and 11.8 kgs)
3. Height is less than 32 inches (80 cms)
4. To maintain stopping performance, clean friction strips regularly with damp cloth.