Stop RuSt DeaD Extend Rust Treatment

Extend Rust Treatment
®
Kills old rust. Prevents new rust for years.
Stop Rust Dead
Brush or spray Extend®
onto any wire-brushed or
sanded surface. Leave on some
rust. Extend® goes on white.
Turns black in 10 minutes.
6 Months: Extend®
continues to prevent rust
even with constant water/salt
spray contact.
1 Year: Even under
continuous high humidity
Extend® still looks new.
18 months later: Extend®
still keeps old rust from
coming back. Prevents new
rust from starting.
PRODUCT BENEFITS
•Easy to use. No Sandblasting. Just wire-brush or sand to remove
heavy layers of rust, clean off any oil, dirt or grease. Brush or
spray Extend® Rust Treatment on surface. It does the rest.
•Converts and primes in one operation. Three coats are
recommended for maximum durability.
•Replaces conventional primer for most industrial finish paints.
•Works on damp, rusty metal.
•Non-flammable and low toxicity.
Don’t just treat rust.
Kill it with Extend®
Extend
®
No more scraping or sandblasting.
No more primers, acid penetrants or conversion washes.
Rust Treatment
Extend® kills old rust and prevents new rust quickly and easily. It is a fast
drying, latex coating that is applied to rusted metal to stop rust, protect the
surface and act as a primer for the finish coat.
TYPICAL APPLICATIONS
Extend® Rust Treatment is used on rusted steel to
stop rust, coat surface, and as a primer for various
covering paints on:
• Pipes, valves, fittings in refineries, tankers,
power plants, domestic and commercial
heating/cooling plants
• Truck trailers, storage tanks
• Fences, guardrails, conveyors, supports
• Overhead cranes, booms, floor
gratings, ductwork
Before
• Outdoor advertising sign supports/frames,
municipal and highway signposts and frames
• Bulkheads, overheads, decks, hatch covers,
stacks on ships (topcoat with appropriate
marine paint)
• Agricultural equipment, harvesters, plows, discs,
tractors, corn pickers, etc.
• Snow removal equipment in highway
department maintenance yards
Performance Characteristics
Extend® Rust Treatment’s unique capability makes it ideal for maintenance
use in applications where sandblasting is not practical or economical.
Extend® gives a quality level of conversion and protection, especially when
followed by conventional prime and/or finish coats. Most finish paints will not
require any additional primer. However, light color latex and metal filled paints
require a solvent base primer on top of Extend® Rust Treatment coating before
finish application.
Extend® was tested for 100 hours at 95°F, condensing humidity, salt spray
(ASTM B117-73), and satisfactory performance was obtained. This test is
equivalent to 2 years of outdoor exposure. Protection is enhanced with Extend®
plus an overcoat such as epoxy, alkyd, urethane, or chlorinated rubber.
• Paper mills, chemical plants, steel mills,
utilities for maintenance of pipes, tanks,
support steel, valves
• Protect castings and stampings before
final machining NOTE: Not recommended where total immersion in any
liquid is required.
Henkel Corporation
Engineering Adhesives
www.henkelna.com/mro
www.loctite.com
After Extend Rust Treatment and fresh paint
Item #
30539
75430
75448
75465
IDH #
234928
234981
160802
234984
PACKAGE SIZE
10.25 oz. net wt. aerosol
1 quart bottle
1 gallon bottle
5 gallon pail
U.S.A.
Canada
Henkel Corporation
Engineering Adhesives
1001 Trout Brook Crossing
Rocky Hill, Connecticut 06067
Tel: 1.800.LOCTITE (1.800.562.8483)
Tel: 860.571.5100
Fax: 860.571.5465
Henkel Canada Corporation
Engineering Adhesives
2225 Meadowpine Blvd.
Mississauga, Ontario L5N 7P2
Tel: 1.800.263.5043 (within Canada)
Tel: 905.814.6511
Fax: 905.814.5391
® and ™ designate trademarks of Henkel Corporation or its Affiliates. ® = registered in the U.S. Patent and Trademark
Office. © Henkel Corporation, 2009. All rights reserved. 5833/LT-5526 (6/09)