Training Part 3B ‐ Getting Started ‐ How to Select Existing Processes How to Select Existing Processes

Training Part 3B
‐ Getting Started ‐
How to Select Existing Processes
How to Select Existing Processes
Sponsored by Lee Slezak
“This presentation does not contain any proprietary or confidential information”
Launch Autonomie GUI - Run aStart.exe
From the desktop
The first time you launch Autonomie, Click “Register” to ensure Matlab is recognized
Or Windows Explorer
2
Select OPEN Menu
2 – Select/Enter you Username (no special characters, no space)
A specific username allows you to create
allows you to create your own working environment => Any file under this directory will only be seen by you
3 – Select “Open a Vehicle”
1 – Select the Open Menu
3
Select the Vehicle “Split Midsize HEV 2wd Single Mode
Default
Default”
1 – Select the Vehicle
Options are Searchable Through Key Words
2 – Validate the Selection
4
Main GUI opens and Shows Vehicle Architecture
5
Click on Select Process Link
Selected
S
l
d Item Explorer
l
i used
is
d to
provide set of available selection
based on the current context.
In this case, one can select
different processes.
6
Click on Select Process Link
Main Screen allows one to view the details of the selected process
7
Description of Processes
Performance Test
List of available CarSim procedures
C td
Coast down Test
T t
Evaluate a Single Component (used by experts to develop low level control or validate models
Used to Only Build Model or Run Cycles
Example of Proprietary Processes
Gradeability process
Process to generate lookup table from GTPower engine model
List of all cycles for fuel consumption
Certification procedures (2 cycles, 5 cycles, PHEV J1711…)
Steady‐state speed traces
8
Description of Simulation Steps
1 – Select Run Acceleration
Optional
The simulation steps shown
by default are the ones that
have
(1)parameters that can be
modified or
(2) are optional
Uncheck
the box
to view
all steps
9
When the Simulations or Simulation Step is
Selected the List of Modifiers Appears
Selected,
OR
10
Description of Modifiers
M difi
Modifiers are used to perform specific actions on processes
dt
f
ifi
ti
Used for debugging
Allows use of Simset rather than Sim
Avoid rebuilding the model when several cycles are run successively
Run parametric study all combinations
Run parametric study (one parameter changed at a time)
Associate a report to a process
Associate a report to a process
SOC correction by repeating cycle n times
SOC correction by changing initial SOC SOC
correction by changing initial SOC
until (SOCfinal – SOCinit) < target
SOC correction by interpolating different fuel consumption cycles to get SOCinit = SOC final
Run 1D optimization
11
Select Modifiers
Drag&Drop the
modifier on the
Simulation Box
The modifier appears
after all the
initialization steps
are completed
12
To Go Back from the Modifiers to the Processes,
Select the Vehicle in the Project Explorer
SSelect
l
the
h Vehicle
hi l to
Access the Process
13
Whenever a Cycle is Used, Its Parameters Can Be
Modified
Acceleration
Cycles for Fuel Consumption
14
Changing the Solver Options
Any of the selections possible
in Simulink are available in
the GUI, including the
advanced options
15
To Select Several Processes, Repeat the Drag&Drop
16
A Set of Processes Can be Saved to be Later Reused
1 - Click on Save
Process Button
2 - Save the Process under
\simulation setup\process
\simulation_setup\process.
Create a new folder if
necessary
17
To View the New Saved Process, the Process Files
Need to be Refreshed
18