dmrc je paper - Om Ranker's Creator

DMRC JUNIOR ENGINEER PAPER 2012
DMRC Junior Engineer Previous Year Papers
With Answers:
Q-1: In PERT analysis a critical activity has
A) Maximum Float
B) Zero Float
C) Maximum Cost
D) Minimum Cost
Answer: (B)
Q-2: Environment friendly refrigerant R134a is used in the
new generation domestic refrigerators. Its chemical formula
is
A) CH C1 F2
B) C2 C13 F3
C) C2 C12 F4
D) C2 H2 F4
Answer: (D)
Q-3: The S-N curve for steel becomes asymptotic nearly at
A) 103 cycles
B) 104 cycles
C) 106 cycles
D) 109 cycles
Answer: (C)
Q-4: In a rolling process, sheet of 25 mm thickness is rolled
to 20 mm thickness. Roll is of diameter 600 mm and it
rotates at 100 rpm. The roll strip contact length will be
A) 5 mm
B) 39 mm
C) 78mm
D) 120mm
Answer: (A)
Q-5: The angle between two unit-magnitude coplanar
vectors P (0.866, 0.500, 0) and Q (0.259, 0.966, 0) will be
A) 0°
B) -30°
C) 45°
D) 60°
Answer: (C)
Q-6: Minimum number of page frames that must be
allocated to a running process in a virtual memory
environment is determined by
A) The instruction set architecture
B) Page size
C) Physical memory size
D) Number of processes in memory
Answer: (D)
Q-7: The address resolution protocol (ARP) is used for
A) Finding the IP address from the DNS
B) Finding the IP address of the default gateway
C) Finding the IP address that corresponds to a MAC
address
D) Finding the MAC address that corresponds to an IP
address
Answer: (D)
Q-8: Consider a direct mapped cache of size 32 KB with
block size 32 bytes. The CPU generates 32 bit addresses.
The number of bits needed for cache indexing and the
number of tag bits are respectively
A) 10, 17
B) 10, 22
C) 15, 17
D) 5, 17
Answer: (A)
Q-9: The goal of structured programming is to
A) Have well indented programs
B) Be able to infer the flow of control from the compiled
code
C) Be able to infer the flow of control from the program text
D) Avoid the use of GOTO statements
Answer: (C)
Q-10: The tightest lower bound on the number of
comparisons, in the worst ease, for comparison-based
sorting is of the order of
A) n
B) n 2
OM RANKER’S CREATOR
C) n log n
D) n log2 n
Answer: (B)
Q-11: A dc cumulatively compounded motor delivers rated
load torque at rated speed. If series field is short circuited,
then the armature current and speed will be:
A) Both increases
B) Both decreases
C) Increases and decreases
D) Decreases and increases
Answer: (B)
Q-12: Moving coil in dynamometer wattmeter connected
A) In series with fixed coil
B) Across supply
C) In series with load
D) Across load
Answer: (B)
Q-13: In an induction machine, if the air gap increased
A) Speed will be reduced
B) Efficiency will be improved
C) Power factor will be lowered
D) Breakdown torque will be reduced
Answer: (C)
Q-14: A CRO screen has ten divisions on the horizontal
scale. If a voltage signal 5 sin 314t+45 deg)is examined
with a line base settings of 5 msec/div, the number of
cycles of signal displayed on the screen will be
A) 0.5 cycles
B) 2.5 cycles
C) 5 cycles
D) 10 cycles
Answer: (B)
Q-15: A 3-phase 50HZ SCIM takes a power input of 30 KW
at its full load speed of 1440 rpm. Total stator losses are 1
KW. The slip and rotor ohmic losses at full load are
A) 0.02, 600 W
B) 0.04, 580 W
C) 0.04, 1160 W
D) 0.04, 1200 W
Answer: (C)
Q-16: The number of digits in octal system is
A) 8
B) 7
C) 10
D) None
Answer: (A)
Q-17: .The number of digits in Hexadecimal system is
A) 15
B) 17
C) 16
D) 8
Answer: (C)
Q-18: What is the output state of an OR gate if the inputs
are 0 and 1?
A) 0
B) 1
C) 3
D) 2
Answer: (B)
Q-19: What is the output state of an AND gate if the inputs
are 0 and 1?
A) 0
B) 1
C) 3
D) 2
Answer: (A)
Q-20: Logic states can only be ___ or 0.
A) 0
B) 1
C) 3
D) 2
Answer: (B)
O.R.C., SCO 371-373, 4 TH FLOOR, SEC 34 A, CHANDIGARH. CONTACT : 78104-11022, 78143-11022
Page 1