Tellabs 1000 Multi-Service Access Series LET Universal Voice Grade Plug-in Card (L-UVG) Overview

DATA SHEET
Tellabs® 1000 Multi-Service Access Series
LET Universal Voice Grade Plug-in Card (L-UVG)
Overview
Features
The Tellabs 1000 Multi-Service Access (MSA) Series Local
Exchange Terminal (LET) Universal Voice Grade (L-UVG) plug-in
card provides six individually provisionable circuits that support
ground start, loop start and reverse battery signaling for applications
such as PBX off-premises lines.
®
The L-UVG card is direct-mapped (non-concentrated) to a corresponding R-UVG card, installed in an Remote Subscriber Terminal
(RST) and provides six dedicated circuits of universal voice grade
services.
Each L-UVG circuit can be independently provisioned as a D4 FXO,
D4 DPT, GR-08 POTS or GR-08 DID circuit. The L-UVG card provides
ring cadence following including ring-ping. Three modes of on-hook
transmission are supported: between ring bursts, loop current feed
open interval, and provisionable full time forward disconnect is supported in POTS mode. The card also supports precision gain adjustment in 0.1dB steps over a 12.0 dB range. The L-UVG can be located
at the RST to support Direct Inward Dialing (DID) applications.
The L-UVG card also supports multiple loop testing systems
including Mechanized Loop Testing (MLT).
Six two-wire circuits per unit
n Software selectable transmit gain (0.1 dB steps)
n Ground start/loop start capability
n Reverse battery (quiet)
n Wide ring voltage/frequency detection window
n Software provisionable 600/900 Ohms impedance
n On-hook transmission
n Compatible with the following test systems:
MLT, Reltec, Teradyne 4TEL
n Support for CMWI (Call Message Waiting Indicator)
n
LED Indicators
LEDs on the L-UVG faceplate
indicate the following:
Green BUSY — one or more
L-UVG circuits are busy or are
being tested and must not be
removed from service
nRed FAIL — plug-in card failure
nBlinking red FAIL — illegal
signaling
n
See tellabs.com for more information about Tellabs Solutions
2 TELLABS 1000 MULTI-SERVICE ACCESS SERIES LET UNIVERSAL VOICE GRADE PLUG-IN CARD (L-UVG)
Specifications
MLT/Teradyne DC Signatures
Signaling
End-to-end signaling delay (normal and
reverse battery): < 50 msec
n
On-hook:
n
–
Pulse distortion (normal, reverse,
pw > 50 msec): < 15 msec
–
Ring detection: < 100 msec
n
AC ringing load (20 Hz): 4 kOhms ± 10 %
–
Ring detector sensitivity:
40 Vrms 17 to 55 Hz
–
Nominal DC input resistance: 800 Ohms
n
n
n
n
Tip to ring: 50 kOhms
Environmental Operating Temperature
n -40° F to +149° F (-40° C to +65° C)
Tip to ground, ring to ground:
430 kOhms
n
n
Nominal DC input resistance in DID mode:
250 Ohms
n
Ring ground resistance: 600 Ohms
n
Tip to ring: 43 kOhms
Tip to ground, ring to ground:
430 kOhms
Off-hook:
n
DLC Test Resources in Use Signatures
n Tip to ground, ring to ground: 167 kOhms
Humidity: 5–95% non-condensing
n
Average power consumption: 1.0 W
n
Tip to ring: 900 Ohms
Off-hook, ring grounded:
Tip to ground, ring to ground:
430 kOhms
–
Width: 0.563 in (1.429 cm)
n
Depth: 10.5 in (26.67 cm)
Tip to ring: 900 kOhms
–
Dimensions
n Height: 5.125 in (13.018 cm)
n
Maximum CO wiring resistance: 200 Ohms
n
Weight
n 0.5 lbs (0.23 kg)
Reltec DC Signatures
Audio
On-hook:
n
Companding: μ-Law
–
VF input impedance (provisionable):
600/900 Ohms
–
n
Tip to ground, ring to ground:
430 kOhms
n
Nominal net loss (referenced 2-wire
600 Ohms): 0 ± 0.4dB
n
Tip to ring: 50 kOhms
GR-1089-CORE
n
Off-hook:
n
Maximum VF overload level: + 5.0 dBm
Tip to ground, ring to ground:
430 kOhms
–
n
Longitudinal balance:
> 58 dB (400 Hz to 3.4 kHz)
–
Two-wire return loss:
ERL > 18 dB, SRL > 10 dB
–
n
Tip to ring: 835 Ohms
Off-hook, ring grounded:
n
n
Transmit gain adjustment: 3 dB to + 9dB
n
Receive gain adjustment: 9 dB to + 3dB
–
Tip to ground, ring to ground:
430 kOhms
Tip to ring: 835 kOhms
n
Compliance
nR-TSY-000057
TR-TSY 000303
n
Next Step:
Visit www.tellabs.com to
learn more about how Tellabs
makes it easy for carriers to
offer new higher-speed services. If you have a question,
please email ask@tellabs.com.
North America
Asia Pacific
Europe, Middle East & Africa
Latin America & Caribbean
Tellabs
1415 West Diehl Road
Naperville, IL 60563
U.S.A.
+1 630 798 8800
Fax: +1 630 798 2000
Tellabs
3 Anson Road
#14–01 Springleaf Tower
Singapore 079909
Republic of Singapore
+65 6215 6411
Fax: +65 6215 6422
Tellabs
Abbey Place
24–28 Easton Street
High Wycombe, Bucks
HP11 1NT
United Kingdom
+44 871 574 7000
Fax: +44 871 574 7151
Tellabs
Rua James Joule No. 92
EDIFÍCIO PLAZA I
São Paulo – SP
04576-080
Brasil
+55 11 3572 6200
Fax: +55 11 3572 6225
The following trademarks and service marks are owned by Tellabs Operations, Inc., or its affiliates in the United States and/or in other countries: TELLABS®, TELLABS and T symbol®, and T symbol®. Statements herein may contain projections or other
forward-looking statements regarding future events, products, features, technology and resulting commercial or technological benefits and advantages. These statements are for discussion purposes only, are subject to change and are not to be construed as
instructions, product specifications, guarantees or warranties. Actual results may differ materially.
© 2012 Tellabs. All rights reserved. 74.1643E Rev. B 4/12